Can someone help me how to setup LED light for Photocatalytic dye degradation?

15 July 2013 1 7K Report

Absorption edge of my photocatalyst is around 410 nm. I want to use small size LED lights. I dont know how many led lights are required and what should be their power.

Tejas Lele

we are developing a reactor for the same and would update on UV LED

Badges
Science topic

More Sridhar Sampath's questions See All

Explain in detail the laboratory and field tests that are conducted on cement. Elucidate the procedures involved?

This question needed to be answered to a civil engineering student studying his first year right now.

22 April 2024 9,118 2 View

Immunoblotting post total protein quantification using SYPRO ruby stain?

Hello all, I am probing for the difference in expression levels of certain proteins involved in fatty acid transport and muscle remodelling in avian skeletal muscle homogenates. I tried using...

03 April 2024 486 0 View

How to improve torque density of motor?

I would like to enhance the torque out of motor by enhancing the dimensions as i have the flexibility to increase the dimensions....In this context I am not changing voltage and current....by...

02 February 2024 319 3 View

Should I add primary data in appendix of my thesis? Is it mandatory?

It is not mandatory, as it is confident data obtained from my subjects. It might lead to judging the students and the institution they belong to. I have the data, but I doubt whether it is...

16 December 2023 6,187 1 View

Preparation of PLA saturated solution?

Is there any solvent with a high flash point (more than 100 degrees C) that can fully dissolve PLA polymer?

01 November 2023 8,816 0 View

XPS peak fitting: Must satellite peak areas be accounted for, while calculating oxide thickness?

Subject: XPS peak fitting with satellite peaks I am currently working on peak fitting Sn3d spectra that include satellite peaks (see attached figure). My aim is to calculate oxide thickness by...

02 October 2023 3,791 1 View

How to do standard curve for total terpenoid content using linalool as standard medium?

I used linalool standard for estimating total terpenoid content for my plant sample, different linalool concentration has been taken and finally the supernatant has been discarded, the red...

04 June 2023 8,036 2 View

Diesel Heater Glow Plug actuation using MOSFET Trigger Module?

Can I supply 12V DC voltage to diesel engine glow plug through a MOSFET Switch module.

03 June 2023 7,983 1 View

Can i actuate a GDI injector using arduino and motor shield combo ?

I had a plan to run the GDI injector for a single pulse injection. This injector draws high current and voltage for its operation. For that I used a GDI injector, Arduino Atmega 2560, Motor...

17 February 2023 256 4 View

Presence of grossular-andradite (grandite) series garnets in nepheline syenite gneiss indicate any carbonate related hydrothermal phenomena?

Dear all, I have nepheline syenite gneisses, consisting of grossular-andradite (grandite) series garnets. Other minerals of these rocks are nepheline (seldom altered), plagioclase, k-feldspar,...

21 January 2023 2,819 11 View

How to prepare the nanoparticle treated fungal sample for Environmental SEM analysis?

A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.

07 August 2024 5,307 1 View

Nano Orange protein quant on the Quantus fluorometer?

Is anyone here using the Thermo Fisher Nano Orange kit for protein quantification, and detecting the fluorescent signal on the Promega Quantus? We are struggling to make sense of the standard...

05 August 2024 8,946 3 View

How to report results of Generalised Linear Mixed Models in a journal article?

Hi everyone, If you have written or come across any papers where Generalised Linear Mixed Models are used to examine intervention (e.g., in mental health) efficacy, could you please share the...

04 August 2024 4,130 4 View

What are possible strategies can be used to analyze data under sequential explanatory mixed method approach?

Better ways to analyze the qualitative and quantitative data in a sequential explanatory mixed method approaches

04 August 2024 2,703 6 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

Is someone interested in testing some of our new Alluaudite compounds (Molybdate) in the fields of heterogeneous catalysis and photocatalysis?

We have an original Alluaudite-Molybdate we want to test for catalysis and photocatalysis applications.

04 August 2024 2,261 1 View

Why aren't most metal oxides insoluble in water?

Why BaO (s) + H2O(l) ---> Ba 2+(aq) + 2 OH - (aq) if Oxygen loves owning all the electrons, why would it bind to hydrogen which competes with Oxygen for electron ownership more so than...

03 August 2024 5,392 1 View

Why chloride turns into chlorine gas in a Downs cell?

I imagine the battery drives the graphite into a carbocation, then chloride is oxidized to donate the electron to the carbocation, but what pushes the lost electrons of chloride to be shared...

03 August 2024 5,384 0 View

How can I find access to heavy metal reference doses from the EPA and WHO websites?

Reference dose and Maximum acceptable concentrations HMs

03 August 2024 8,230 4 View

How to calculate the molar proportions of the oxides from the XRF analyses?

02 August 2024 2,565 2 View