Does anyone have relevant info on this?
Hello !
Yes, it is possible. I suggest you get more information in the literature, you can start with this review:
Chapter Focused Ion Beam System—a Multifunctional Tool for Nanotechnology
Best of luck !
Joao
Yes, it is possible, following article would help you,
Article Multiple-barrier and nanoscale superconducting devices
As the others have mentioned, it is definitely possible. However, it is unlikely to be the most time-efficient method.
If you can give more details on the structure you are trying to create I am sure the RG community can offer suggestions on how best to achieve this.
Jules
In a typical photometry bench (light source at one, photometer under test at the other), is the geometry of the baffle critical? If so, how does one design such baffles? EDIT. Thank you all for...
27 April 2018 4,774 3 View
During aldehyde reductase extraction, the buffer we use contains sucrose, betamercaptoethanol and EDTA. why sucrose?
22 August 2017 4,567 1 View
13 May 2017 8,162 4 View
I run a PCR with the sputum product which was microscopy positive, but after PCR the result was negative.
03 March 2017 9,847 3 View
Used for the separation of large aggregates.
22 February 2017 4,674 3 View
10 January 2017 5,465 3 View
23 June 2016 7,863 4 View
On conceptual structure: Are some concepts built out of (and, therefore, reducible to) other concepts? Is this the case only within particular theories of concepts (e.g. the Classical Theory,...
02 June 2016 1,792 3 View
13 August 2013 3,887 3 View
Hi all, so much has been said and written about the role of influencers in influencer marketing. So far, most studies focus on influencers in terms of their number of followers, thus we have nano,...
01 January 1970 6,419 3 View
It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...
24 February 2021 5,974 4 View
Hello all, I have used Amberlite IRC120 H, hydrogen form acidic cation-exchange resin for the ion-exchange of waterglass [sodium silicate solution -- 40% Sodium silicate (mol ratio > 3.2)...
21 February 2021 5,614 3 View
Hello, I am trying to make anode for Na-ion batteries. I have no experience with preparation of the electrolyte for any batteries. NaClO4 salt are available and I am planning to use EC:PC as...
21 February 2021 8,132 1 View
I am trying to simulate a simplified version of a beam resting on 10 points using Abaqus. The solutions I want to obtain are the Reaction Forces in each resting point or area when applying a...
21 February 2021 3,075 2 View
I am working on transparent/translucent zirconia-based ceramics. In many papers, I have seen that they are reporting both In-line transmission (%) & Total transmission (%) value of...
20 February 2021 9,405 6 View
I am trying to simulate the impact of a sinusoidal force on a Beam, yet I registred this beating signal (Displacement by time). The freaquency of excitation was the same as the first natural...
19 February 2021 5,872 3 View
Hi, A Fabry Perot Cavity allows to increase the directivity of a low gain antenna by putting in the top of cavity a superstrate with high permittivity such as a ceramic (er=10.2). However,...
09 February 2021 6,799 8 View
During the resin (XAD-8) fractionation of wastewater salts (NaOH or HaCl) are used for acid or base elutions/pH adjustments. Since the amount of introduced salt is minimal, so is it required to...
08 February 2021 9,489 2 View
Recommendations in preparing ceramics for nanoindentation and in the process minimize introducing stresses from sample preparation i.e. polishing stage.
02 February 2021 6,211 3 View
I have Submitted 2,3 Papers in Science Direct associated Journals but the time of the first decision has been ended so What should I do? Could I email them to remind them about the first decision?
01 February 2021 5,788 7 View