Can anyone suggest me a filter membrane suitable for graphene oxide quantum dots?

11 November 2017 0 9K Report

i want to prepare graphene oxide quantum dots and in all the papers that i have referred to, it is mentioned that 0.22 micrometer millipore filter membrane have been used. But i want to know the material of the membrane that is suitable for such quantum dots.

Badges
Science topic

More Koustav Kashyap Gogoi's questions See All

CdS/PMMA matrix was prepared by dissolving PMMA in chloroform and it has stuck to the walls of the test tube. what is the procedure to clean it?

A matrix of CdS/PMMA was prepared by trying to dissolve PMMA in chloroform. But PMMA did not dissolve in the solvent and after keeping the solution as such , the PMMA has stuck to the walls of the...

10 November 2016 1,996 2 View

What are the values needed for gabor filter's parameter for cifar10 data?

Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...

03 March 2021 6,317 1 View

How to calculate Total Flavonoid?

I analyzed flavonoid total spectrophotometry, the procedure as below: 2 ml supernatan added 5 ml dd.H2O, then added 0,15 ml NaNO2 5%, 5 minutes later added 0,15 ml AlCl3 10%, After 6 minutes,...

01 March 2021 6,722 1 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

RNA-seq DEGs downstream analysis and reporting in literature?

I used EdgeR to get the list of DEGs (differentially expressed genes) from my liver RNA-seq experiment. I have done the gene overrepresentation and GSEA based pathway analysis. I am currently...

23 February 2021 8,969 1 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

What are the ranges of four diffterent poles of butterworth filter for ECG signal?

Hi, Can anyone please tell me what are the ranges of four different pole orders such as first order, second order, third order and fourth order respectively of butterworth filter for ECG...

23 February 2021 2,554 3 View

Which polarizers are usually used to measure the birefringence of zebrafish muscles?

I already found several publications on that topic, however, the specifications for the used filters are often missing. Some more specific information than "fish is placed between to polarizing...

23 February 2021 1,934 1 View

Is there an ideal incubation time of RGO-modified SPCE before subsequent use, i.e., electrochemical characterization or further modification?

I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...

22 February 2021 5,324 3 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Is it possible, for a limited dateset of images, to use Convolution filters + Random Forest instead of UNet?

UNet is 'relatively' recent and was invented mainly to deal with biomedical images, yet is it also possible, for a limited dateset of images, to use Convolution filters + Random Forest instead of...

21 February 2021 4,858 3 View