can anyone help me with matlab codes for modelling fuel cells using genetic algorithm
How to model a PEM fuel cell using genetic algorithm. which are the softwares utilised?
10 November 2017 3,101 0 View
can any one share matlab codes for designing a pem fuel cell. Basically to design a model and vary its electrical parameters?
08 September 2017 9,981 1 View
modelling of fuel cell
04 May 2017 5,473 0 View
can we vary the parameters of the fuel cell source which is readily available in simulink, if yes, how to do it? basically i want a higher output fuel cell source,how can i model it using matlab
05 June 2016 8,459 1 View
how do we infer that the battery has regained its capacity post recharging?
05 June 2016 6,559 0 View
i need voltage output of 360v to 504 v DC from the fuel cell and a minimum load current of 220 A.
05 June 2016 3,369 5 View
I'm dealing with a mediation model and am using the PROCESS module in SPSS. Due to SPSS and PROCESS being limited in the imputation methods - being unable to handle multiple imputation - the other...
02 March 2021 4,362 1 View
Hello all, In SPSS I am going to code 2 open-ended questions. I have already read all the answers and I made a list of the most important categories to which I can code the answers. This question...
02 March 2021 1,757 4 View
NFL theorem is valid for algorithms training in fixed training set. However, the general characteristic of algorithms in expanded or open dataset has not been proved yet. Could you show your...
01 March 2021 1,189 3 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...
28 February 2021 6,560 14 View
I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...
28 February 2021 3,459 3 View
I am working on modeling and simulation of biomecanical material behaviour, I have succeded on simulating skin using anisotropic hyperelastic material, on APDL and in our lab's finite element...
28 February 2021 552 3 View
I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...
25 February 2021 5,435 2 View
Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...
25 February 2021 8,053 5 View
I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?
24 February 2021 5,602 2 View