Can anyone help me designing ulta Semiconductor Devices?

More Mihir Ranjan Acharya's questions See All

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Hello everyone！ I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...

05 August 2024 5,729 2 View

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...

03 August 2024 5,358 0 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...

29 July 2024 7,198 9 View

Are air moisture harvesting technologies effective in combating desertification?

Air moisture harvesting Air water collection devices

06 August 2024 5,473 2 View

Best mask design for metal deposition aiming build a Perovskite solar cell device?

What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?

31 July 2024 4,835 3 View

¿Are oxygen vacancies in semiconductors capable to change the band gap?

Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...

30 July 2024 8,339 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Which software tools are best for enhancing diagnostic accuracy in chest X-ray imaging using image reconstruction and neural networks?

I am reaching out to seek your valuable advice and recommendations regarding the best software tools to use for this research. Specifically, I am looking for software with a user-friendly...

22 July 2024 3,794 1 View

I want to conduct a research using quasi experimental design to test two treatment and one control what type of statistical tools do l use ?

What type of experimental design do l use and what statistical tools do l use for the hypothesis. What is the position of control group in the analysis?. Thanks

18 July 2024 3,581 3 View

Charge transfer characteristics of inverted perovskite leds?

When testing devices based on ITO/ZnO/CsPbBr3/TFB/MoO3/Ag structures, I found that the current density of the device always increases sharply to 1000mA/cm2 at about 3V bias, and the device does...

16 July 2024 4,291 0 View

Which research tool for expert validation for our study?

I am a 3rd year Computer Science student currently writing our Bachelor's thesis about finding diverse k-shortest paths in pedestrian networks. We have chosen 3 local areas as our proposed...

15 July 2024 4,289 0 View

Figure plot in scientific articles?

Hi all, Do you know how to plot this figure? I found many of them in Nature journals but have not figured out how to make them. Which software/tool do you suggest? Thank you very much.

15 July 2024 8,384 2 View

Can it is possible to find the cleaved sequence when a protein cleaved by a heamaglutanin protease (HA/P) by any bioinformatics tools?

Bioinformatics tools like peptide cutter

15 July 2024 6,453 1 View

Laurent Artola

You could use TCAD simulators, such as Synopsys TCAD or Silvaco TCAD

Manish Deshwal

Please read this article and choose accordingly for your needs

https://en.wikipedia.org/wiki/Electronic_design_automation

Niladri Pratap Maity

By only Silvaco TCAD (ATLAS & ATHENA) and Synopsys TCAD

Aleksandr Vasilev

Hi. in addition Cogenda and Crosslight. But I do not work in then. As for me best program is Silvaco.

Sumit Kale

U can use the silvaco atlas and Synopsys tcad for semiconductor device design....