Can anyone give reference to see TVD MacCormack scheme merits and demerits? TVD MacCormack scheme

10 October 2013 0 5K Report

I am interested in knowing more about the TVD MacCormack scheme merits and demerits.

Badges
Science topic

More Ashwani Assam's questions See All

MacCormack Scheme face value calculations - any thoughts?

For the finite volume scheme we need the value of the conservative variables on the faces of the cell. For this as stated in Jameson, 1981, we use the average of the value on either side of the...

03 April 2014 4,537 4 View

Subsonic or transonic flow over a bump in a channel?

We prescribe stagnation pressure and temperature at subsonic inlet (physical BC). Now we extrapolate velocity from inside the solution domain (numerical BC). For calculating internal energy (e)...

31 December 2013 3,523 3 View

Which artificial dissipation term is best for Euler equations?

I am using the MacCormach method using finite volume formulation.

09 October 2013 4,162 6 View

Compressible Fluid Flow Validation required.

I need to validate our Euler solver. I am getting result for 2D flows. At present I am trying to validate 3D airfoil (NACA0012). I am looking for some problem in 3D which is easy to mesh. Our...

09 October 2013 4,719 7 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Arena simulation - how do i model the following model in ARENA (see description) (new to ARENA)?

Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...

02 March 2021 2,431 3 View

How to code open-ended questions in SPSS?

Hello all, In SPSS I am going to code 2 open-ended questions. I have already read all the answers and I made a list of the most important categories to which I can code the answers. This question...

02 March 2021 1,757 4 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View