Can anyone can recommend best Real Time PCR open platform for molecular diagnosis of infectious diseases (HIV,HBVHCV and HPV etc...)

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

How do I increase the yield of my PCR product?

Hello, We would like to increase the yield of our PCR product. We are running a series of PCR reactions that is targeting ~1.1kb sequence. We begin each reaction with ~400pg of template DNA...

02 March 2021 4,029 3 View

How to quantitative analize the data of TNBS assay for gelatin?

Estemeed colleagues, I found some issues regarding the quantification of the data for TNBS assay. There are different protocols on how to perform that but it is clear to me the "fil rouge" that...

02 March 2021 2,616 1 View

Research on Supply Chain Management in Indian context?

Hi, I am planning to apply for the PhD degree in the Supply Chain Mgt. with specific area of "Cold Storage warehouses" during Pandemics and wars. Where lock downs and shut downs are frequent....

02 March 2021 285 2 View

PACYC PCR not working after several attempts. Would anyone have any suggestions?

So, I have been trying to run a pACYC PCR which will be used later on for a Gibson Assembly. However the PCR is not working. I have already tried gradient PCR and changing extension time; however...

02 March 2021 1,146 2 View

How to address this issue in the analysis of Real-Time PCR results?

To dear Researchers, I was analyzing a series of concentration for estimation of Real-Time PCR efficiency. The concentration was 1:10. I used MS-excel to evaluate Slope. The result of slope was -8...

01 March 2021 8,683 4 View

How to accurately quantify chitin?

Hi all, I have been working on the quantification of chitin in insect samples and feed for a while but I can notice that the quantification methods (e.g. exposure to HCl, NaOH, and weighing sample...

01 March 2021 1,843 2 View

Why is the efficiency of viral mRNA electroporation in PBMC low?

Hello, I have been struggling with the electroporation of PBMC with HIV-I mRNA. Although the quality of the RNA generated is good, and the handling of the cells in meticulous, the frequency of...

27 February 2021 9,233 3 View

Runs of nucleotides in Sanger sequencing?

I performed site directed mutagenesis, transformation, and then I sent out plasmids for Sanger sequencing and found out that there is extension of DNA just before the stop codon. I am not sure...

27 February 2021 547 3 View

Can thermal cycler machines be problematic during PCR?

Hi, my question is about the heating of thermal cycler machines and I hope some of you had experienced a similar thing previously. There are two thermal cycler machines in the lab(BioRad) and for...

26 February 2021 4,777 4 View

Shilpi Gupta

Hello,

In my opinion, You only prefer applied bio-system (Thermo) fully automated Real-time PCR.

Good luck

Navnit Kumar Ramamoorthy

Dear Salesh,

You are an entrepreneur and I suppose you will be making a huge investment in this regard. My modest advise to you would be to converse in detail with the application specialists of each of the top brands. They will provide you with the required testimonials; Furthermore, rivals would be able to point out the shortcomings of the other. After a thorough analysis, make a decision.

Sibnarayan Datta

Dr Chandran,

If your funds permit, consider going for a droplet digital PCR. It has lot of advantages over conventional Real Time PCR.

regards,