How can I define "Heat Transfer in Fluids" for water that flows through an air domain and reaches a Wetted Wall in COMSOL Multiphysics for a 2D model?

Hi all, I hope everyone is doing well and is in good health. In the simulation it is needed to change the phase of water that flows through an air domain. So I used Laminar Flow and Level Set...

25 November 2020 365 4 View

How to propagate the EMC Virus in L929 cell line?

04 October 2020 6,705 2 View

How can I interpret a NMR with so much noises and peak overlaps?

Ideally peaks should be separated and having a somewhat symmetric pattern but could any one give me a help with reading H NMR with multiple peaks totally mixed up which could not be attributed any...

22 September 2020 3,667 3 View

Any recommendation for a good Machine learning course (with available materials for instructors)?

Hello everyone, I am looking for a good recommendation for a Machine learning course (with available materials). Which one do you suggest? Something that would be up to date with available...

15 September 2020 1,674 17 View

Have you ever seen that 40S and 60S of ribosome subunit peaks disappear from polysome fractionation?

I am doing polysome fractionation for stress conditions for mammalian cell. it seems that peaks of 40S and 60S disappear during stress condition compared to control. I am wondering whether all...

12 November 2018 3,513 2 View

What is the reason for change in mRNA level of specific gene but not change in protein level?

With treatment of cell lines ( cardiofibroblast cells), changes in mRNA level of the gene of interest has been observed overtly, but there is no change in protein level. I am wondering how this...

19 August 2017 1,026 6 View

Software to Predict Antigenicity

17 August 2015 6,400 3 View

What is the effect of immidazole on activity and stability of enzyme?

When enzymes were eluted with high concentration immidazole, some of them lost their activity in 2 days. I want to know how immidazole affect enzyme or other protein. I can't find article about that.

19 January 2015 7,283 6 View

How can I solve the low speed of my simulation in simulink?

I have a multi machine power system, and I had to simulate it by solving differential equations of the whole system in simulink, but the speed of the simulation is very low, how can I do this...

28 October 2014 7,921 15 View

How can I determine ph stability of my enzyme?

I provide mix buffer containing 100 mM glycine, 100 mM tris, 100mM succinic acid and 100 mM imidazole with ph 3, 3.5.....9 25 microlitr enzyme in tris buffer with ph 7.5 was mixed with 50...

13 September 2014 124 19 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Can we classify HV and LV lines based on line length?

I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...

03 March 2021 4,116 4 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View