We prepare thin film of ZnO:Co by laser ablation but the peaks intensities are very weak like amorphous . Why?
Dear Marcin,
Thank you very much ,I need 2 theater ,hkl and d for all peaks (stander table).
Regards
Ghaleb
Thank you very much.Yes it is.
With Best Regards
Dear Prof. Dr. Galeb AL-Dahash
The attache two files for Zno diffraction pattern card no. 36 -1451with peaks and lattice constants a and c , (hkl) , 2 theta and the intensity . Best regards.
Dr. Adel H.Omran Alkhayatt
Dear Dr. Adel,
Thank you very much.If you have diffraction pattern of CdO, Fe and Fe2O3 ?
Dear Prof. Ghaleb
CdO Cubic 05-0640
Fe Cubic 06-0696
Fe2O3 Maghemite-C Cubic 36 1346
Fe2O3 Maghemite-Q Tetragonal 25-1402
Fe2O3 Hematite, Hexagonal 33-0664
Kind regards
Dr. Adel
Thank you very very very much.
Best Regard
In ICCD indices you can find this information. Regards, José M. Amigó
Dear Sir,
Thank you very much
I need software for calculations for solar cell
15 March 2024 2,467 1 View
during our works and results, we showed no nonlinear absorption coefficient for nanoparticles but there is nonlinear refractive index?
15 January 2023 6,791 3 View
We are deposition of VO2 thin film with CuO and ZnO .
04 May 2018 2,623 2 View
I want to study optical properties of Cu2O-ZnO-Fe2O3 composite and doped with VO2 by PLD as a thin film.
09 October 2017 7,006 0 View
I need a software to calculating thickness and refractive index of multi layers anti reflective coating to enhance solar cell efficiency.
03 April 2017 8,115 5 View
What is the best method to prevent aggregation during preparation of Au , Ag , Ag-Au core-shell collide by laser ablation. We suffer so much from the state of agglomeration during the preparation...
02 March 2017 3,119 5 View
we work on increasing the efficiency of solar cell by deposit Anti-reflection thin film .
02 March 2017 9,432 5 View
We work in Dyes solution,we need to enhanced optical properties by make laser ablation of Ag in this dyes solution.
13 December 2016 9,231 6 View
A specialist in X-ray diffraction data analysis can distinguish the crystal structure directly from the diffraction peaks
05 June 2016 6,279 4 View
We are working in laser ablation of metal targets (PLD) to prepare thin film in nano range and studying all physical properties.
08 May 2016 5,359 8 View
i am unable to interpret why its increases in start as shown in figure
11 August 2024 2,179 1 View
I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.
09 August 2024 9,894 2 View
Require for Rietveld refinement in XRD.
08 August 2024 3,081 2 View
During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...
06 August 2024 726 3 View
I want to refine one XRD peak of my in-situ xrd but the background is never working good which ultimately fails the refinement. How to refine and adjust the background using GSAS-II
05 August 2024 5,291 2 View
I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...
05 August 2024 3,290 1 View
How to calculate the molar proportions of the oxides from the XRF analyses?
02 August 2024 2,565 2 View
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,789 4 View
What information we can get from PXRD analysis other than from SCXRD analysis of a crystal ?
30 July 2024 6,261 4 View
I will be doing an XRD on a sample which is powdered in natured and is a hydrogenated compound. I would like to know how we can understand the individual components and components by using the...
28 July 2024 4,548 2 View