Dear Researchers
Thanks to all
What are the soluble contents of Detergent Powders in ethanol and how can it be analysed.
Balakrushna Padhi
The most common components are:
1. Alcohol Ethoxylate (AE): which is a Non-ionic surfactant that Removes greasy stains from your garments
2. Alkyl (or Alcohol) Ethoxy Sulphate (AES) and Alkyl Sulphate (AS) is an Anionic surfactant.
Two of the most widely used tools for removing stains.
To analyse them FT-IR spectrometer and 13 C-NMR can be opted.
Water-soluble components can probably be analyzed with ESI mass spectrometry quite well.
analysis of colloidal silica in filter water for generation of ultra pure Water
04 May 2017 9,092 0 View
Other than Di-vinly Benzene and Styrene. What is the dilution solvent.
09 October 2014 292 2 View
Dear Dr KumaresanThanks for your communication. Can u send related publications the composition of Crystal Growth Modifier and the degradation organics products produced after addition of CGM in...
01 January 1970 1,384 0 View
How to determine the HLB value of crystal growth modifier used for growth and suppression of Oxalate in Bayers liquor
01 January 1970 5,929 2 View
..
05 August 2024 4,407 0 View
99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified
31 July 2024 5,113 4 View
Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.
29 July 2024 6,350 3 View
Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco
29 July 2024 2,163 1 View
Kindly share a research paper that explains the effect of Methanol and ethanol treatment on collagen based scaffolds. How it increases porosity and swelling. Kindly help me find a paper. Thank you
24 July 2024 3,937 0 View
I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...
23 July 2024 9,938 1 View
I was performing estimation of Total Soluble Sugar content in bacterial cultures by Anthrone method. Out of 9 samples, only one sample showed positive reading while others had a negative reading...
22 July 2024 9,576 4 View
I am searching for HPLC method to estimate Mirtazapine but i want to avoid HPLC-buffers as a mobile phase component. So, I am looking for alternative HPLC-solvent (acetonitrile, methanol etc.)...
14 July 2024 1,493 3 View
I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...
13 July 2024 9,003 2 View
I am trying to load curcumin emulsion in 4% chitosan gel but i don not know how many mg powder is needed ?
10 July 2024 2,462 1 View