Calculating the Relationship Between Alkalinity titrations, DIC, and pH?

15 February 2024 0 6K Report

Hi folks,

We collect pH readings in situ, conduct an alkalinity titration on site, and measure total DIC. I am looking to do some Q/A QC on our carbon system calculations. Could someone point me toward the equations for calculating DIC from pH and an alkalinity titration? Thank you!

More Paul Helfrich's questions See All

How to perform Cox proportional hazard analysis or Kaplan-meier survival analysis in SPSS?

At first please see the attachment. This experiment was performed for a period of 7 days (n=100). After 7 days, we found different level of survival rate (%) for each treatment. Now, I want to...

15 February 2021 9,145 2 View

For acid treated montmorillonite clays what will be the result of surface area?

The organo montmorillonite nanoclays modified with octadecylamine were used for the experiment. After acid treatment, the surface area will be increase. However, in my experiment, the surface area...

10 February 2021 1,581 3 View

How to identify when a gaussian program is about terminate normally?

Dear all, I am trying to optimize a bimetallic complex using # opt=tight b3lyp/lanl2dz scf=qc geom=connectivity. The program is running for around 5 days but the size of the .chk remains same...

05 February 2021 8,721 3 View

Can I use 500ng of DNA for restriction digestion?

The recommended amount of DNA for restriction digestion is 1ug in a 50ul rx I've got around 500-600ng of DNA in a total volume of 35ul. Would I get satisfactory results with this amount of DNA for...

31 January 2021 729 6 View

What is the effectiveness of online teaching during COVID-19?

Please share your experience on the effectiveness or challenges on online teaching during Covid-19 lock down. Share your experience about challenges, technology, online learning platform,...

26 January 2021 4,532 37 View

LC-MS metabolomics data after annotation some have their compound name but no KEGG id or with KEGG id but no pathway. How to interprete?

Recently I have generated LC-MS metabolomics data. After annotation, some have their compound name but either no KEGG id or KEGG id but no pathway. How to interpret those compounds? Additionally,...

18 January 2021 1,938 3 View

Has there been any scholarly research done in schools that addresses teaching from a global citizenship perspective to deal with global problems?

The current global pandemic, the climate crisis, the destruction of the oceans (with plastics, etc), and massive numbers of refugees are part of a set of serious global problems. It is clear...

13 January 2021 2,022 3 View

How to remove a citation from list of research articles?

I want to remove a duplicate citation

01 January 2021 3,983 3 View

No executable file generates while building geant4 example code, where is the problem?

Hello, I am a newbie in geant4. I'm learning it playing with example. Sometimes, when I go to simulate an example code, it doesn't create an executable file (the green one in my ubuntu terminal)....

26 December 2020 9,482 3 View

How to get structure and topology for glycosaminoglycan (GAG) of arbitrary length?

Hello all, I want to do glycosaminoglycan (GAG) simulation in Gromacs. Initial structure and CHARMM topology for short chains can be obtained from Charmm GUI glycan modeler. But I have to take...

23 December 2020 6,092 2 View

Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

Chlorinated organic formation in odor control scrubbers using hypochlorite?

I'm involved in a study of odor control technologies for municipal wastewater treatment plant. One of the control options involves a chemical 2-stage (acid/alkaline) packed bed scrubber. The...

03 March 2021 3,661 2 View

How to quantify carbon deposition on CuZnAl catalyst?

Dear All, I want to quantify carbon deposition on the surface of the CuZnAl catalyst. I have tried thermogravimetric analysis, but I've got weight gain as the active Cu- get oxidised. Does anyone...

01 March 2021 1,907 3 View

Why Trivalent chromium start precipitating above PH 5 ? Moreover discuss difference between adsorption of chromium and precipitation of chromium ?

I am a student of MS Environmental Engineering and started my research phase. I am working on metal removal ( chromium iii ) by using activated carbon prepared from the agricultural feedstock. So...

01 March 2021 5,475 2 View

How can I assign a velocity along one direction to CO2 molecules in a molecular dynamics simulation using GROMACS?

Dear all, I am trying to perform a MD simulation about the interaction between CO2 and a polymer. I create my model, solvate it and perform the NVT and NPT equilibration. Now I am not able to...

26 February 2021 10,014 3 View

Which database would give me this list of chemical components?

Dear colleagues: I would like to know if anyone knows of a database that gives me the parameters pH, K, K, Mg, P, C, N, Zn, Cu, Ni and Cd of common foods. I find a lot of information of proteins,...

26 February 2021 5,525 3 View

CGA 300 Regulator for CO2 cylinder?

Has anyone ever tried to deliver CO2 with a CGA 300 regulator? I know that a CGA 320 regulator is standard for CO2. The issue is that I currently do not have any free CGA 320 regulators. I also...

25 February 2021 3,292 3 View

What are the methods used for CNT..?

Respected Professor's i hope you are doing well and happy. i need some information about carbon Nanotubes. before blending the CNT with the matrix the CNT has been introducing in some treatments....

24 February 2021 5,383 5 View

Why is NH4OH added in heavy metals limit test?

The limit test I'm referring to is USP method II. In this procedure you need to dropwise add 6N of NH4OH to the sample until it the pH is alkali. After that you need to dilute and add HOAc until...

23 February 2021 2,049 3 View

Best plasmid could be used as a standard curve for AAV titration?

I have been trying to have a good AAV titration for my production and I have tried different plasmids to set up as a standard curve but each one behaves differently. i am trying to use ITR for...

23 February 2021 5,167 3 View