I am trying to conduct a shear force analysis in a 3D beam which is 32x69 and length 1.8m material pine. There is a point load in the center of the beam so 0.9m along the beam. It is simply supported so a fixed edge on one side and a directional support on the other with no freedom in the y and x by free on the z plane. the beam is made of two parts where a bonded connection was made to make it effectively one body and the point load is applied as a force on the edge where the two beams contact. I know in 2D there is a beam tool to look at shear force but can't seem to do it in 3D any solutions for this please?