Hi
This geometry has some serious issues.
When you look at the bottom of it, the face is actually made up of 2 surfaces. Moreover
when you look closely you will find a gap between those faces which goes deep inside
the geometry.
I don't know what question should i ask, its just i want to fill that space. Without that I am unable to mesh it in ANSYS.
Is recreating the geometry the only option?
I think you can make use of hatch or pattern for filling this gap.
Hi Aagam.
Your object was not made of surfaces. It is composed by solids and there are some errors in the geometry of the lower side of one of them, creating a gap. If you just want to close the gap with a surface, just make two polylines with both edges of the gap and make a region with them. If you also want to fill the interior space between the two volumes you can extrude this region toward the interior of the object and make a solid union with the original object and the extruded region.
I have made the closing region for you. Here it is.
Regards.
- Badges
- Science topic