Are there any references about how to calculate the electrical resistance of an alloy with known components?

More Amirmansoor Ashrafi's questions See All

Operating with Scanning electrochemical microscopy?

Dears I am going to rerun a scanning electrochemical microscopy . It is from CH instrument. I can make a nice CV of the ferrocincarboxylic acid as the mediator with both the UME and the substrate...

31 December 2017 3,454 7 View

How is the cyclic voltmeter with four electrodes configurated?

I want to use a four electrode configuration in order to characterize the ion exchange membrane which is located between a two-cell compartment. There must be four electrodes including two Pt as...

09 October 2014 3,900 3 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

How select composition for ods-high entropy alloys?

31 July 2024 2,795 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

I am trying to obtain microstructure for Mg-Zn-Sn alloy?

Any suggestions with respect to etchant composition and holding time?

27 July 2024 6,925 2 View

Will the catalytic effect of retained austenite happens in steels including RA?

The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...

27 July 2024 8,508 0 View

What is the best way to drop a plasmid?

Please address the best way to drop a plasmid. Background: I have a "bait" plasmid resistant to kanamycin and a "prey" plasmid resistant to carbenicillin. After many rounds of streaking on...

25 July 2024 2,532 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

What binders suggestion that I can use for zinc alloy?

I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...

13 July 2024 9,003 2 View

Mohamed Akbi

There is a very nice discussion about this topic following the link below.

https://www.researchgate.net/post/Why_does_the_resistivity_of_an_alloy_need_to_be_between_those_of_its_components_or_at_least_similar_to_them

Amirmansoor Ashrafi

Thank you so much Mohamed. It was such a helpful source.