organic heat recovery fluid
REFPROP is also a great option that is very useful. It's not free ($250 US), but it's maintained by the US National Institute of Standards and Technology.
Hello,
I find this document on the www. It could help if you don't already have it.
Your sincerely,
JF ANTOINE
Dear Anoop
a standard reference for thermodynamic properties is:
Bruce E. Poling, John M. Prausnitz, John P. o'Connell:
The Properties of Gases and liquids.
McGraw-Hill, New York, 5th ed., 2000, ISBN 0-07-011682-2
You'll find this book in every good university library (or perhaps on the internat).
For your purpose, a much older book might be "ready to use" as it offers thermodynamic graphs, tables and computational equations.
William C. Reynolds:
Thermodynamic Properties in SI.
Published by the Department of Mechanical Engineering,
Stanford University, Stanford CA (USA), 1979, ISBN 0-917606-05-1
Let me know if you don't find this book (I have a copy of the book and I could send you a scan of the important pages by email).
Best regards
Nikolaus
How we should screen out the solid material left after 90 days of fermentation in making of garbage enzyme. Is there any standardized process.
17 June 2024 4,840 3 View
My friend who is a Credit Review Officer is working on a research project. The outcome need to be published hence facing difficulties. Bank of Bhutan is not allowed in institution details. Any...
06 June 2024 990 2 View
Hello Peers, Warm wishes to all. I am a new user of the Cytiva AKTA Start system for SEC with a column, HiPrep 16/60 Sephacryl S-100 HR (120 ml column volume). I am not sure about the minimum...
03 June 2024 7,713 2 View
In many organisations , especially within the traditional style of operations,. HR sometimes plays the role of a destroyer, then a team builder. Personal grudges, personal expectations, , personal...
01 May 2024 9,256 5 View
Hi peers and experts! I am new to 3D-QSAR and tried to build a model based on 34 molecules, split into 10 test and 24 training sets. In the end, a poor model is evident from r2 and q2 values....
08 April 2024 2,785 6 View
Here I have given the copy of the error which i have mentioned . Executing Formchk => "C:\G09W\formchk.exe" /3 "C:\Users\DELL\Downloads\chloroform_new_uv - Copy.chk"...
16 January 2024 888 0 View
What is the concept of repeated earthquakes? How does the dynamic analysis is performed under repeated earthquake? Is this done in a different way that IDA analysis? How the ground motion data...
02 November 2023 4,884 4 View
I required some data for the study related to QE of solar cell, but the problem is that I am getting negative QE values at higher wavelength range or at photon energy less than the band gap of...
11 October 2023 5,729 0 View
I am trying to verify the results obtained by modal analysis and response analysis of a G+4 RC hill Building with the base paper results but unfortunately couldn`t. Although I have followed all...
09 October 2023 7,390 9 View
Are there any regulations or standards (National or International) available for quantifying the carbon footprint neutralization by countries, industries, or organizations? By neutralization, I...
15 September 2023 2,836 1 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,227 2 View
Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...
28 July 2024 5,771 2 View
Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?
27 July 2024 648 3 View
What is the thermal expansion coefficient of human muscle?
27 July 2024 7,190 0 View
Accredited laboratory of JV "Uz-Kor Gas Chemical" LLC (Uzbekistan) is looking for providers to conduct interlaboratory comparison tests on gas chromatographic analysis of hydrocarbons (component...
25 July 2024 8,108 0 View