I performed a Crack Propagation analysis using XFEA in Abaqus. The result is showing that the crack is propagated and the crack length is increased, however when I plot the result, I see the crack is all the way propagated. I could not see the crack propagation gradually. I think my visualization setting needs to be adjusted and then I will be able to see the crack propagation element by element. Any help will be appreciated.
Hamid
Hi.
You should check the two field outputs to crack the field output Activate tick . I've shown in the image below.
Hi Mojtaba
Having only "PHILMS, Level Value phi" checked would be enough. The only thing that I changed was my setting for the visualization. However thank you for responding to my question.
Thanks,
Hamid
I am getting 'Vis' error on line 87 in my python script.How can I solve this error? I have attached my code herewith.
I think that you need to put check mark for "PHILMS, Level Value phi" while you recording macro and then insert that code to main python code.
- Badges
- Science topic