Aliphatic polyurea is claimed to be light stable. why TiO2 (TITANIUM DIOXIDE) is added in aliphatic polyurea in most formulations?

Khanisya Palaniandy @Khanisya_Palaniandy2

24 September 2019 0 5K Report

TiO2 gives stability and prevent degradation of sample when exposed to light. But why is it added in aliphatic polyurea if aliphatic polyurea is already light stable? How does this make aliphatic polyurea more advantageous than aromatic polyurea?

Badges
Science topic

More Khanisya Palaniandy's questions See All

How do I calculate NCO content of a quasi prepolymer?

NCO content of IPDI(isophorene diisocyanate) is 37.5%...Some papers claim that the NCO content after mixing this IPDI with D-2000 in 1 to 1 ratio results in 15%.... How do I calculate this?

07 August 2019 5,740 2 View

Controlling for pupil light reflex when analyzing pupil size time course?

I used eye tracking to examine how participants from two different populations (A and B) react to an image. Participants in population A exhibit larger pupil sizes over time, but they also have...

10 August 2024 3,229 0 View

Who of all of you will help TPEOM to re-originate the Earths atmosphere to it original 5 atmospheric elements/gases?

Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...

06 August 2024 8,716 0 View

Hello, regarding Mxene 2D titanium carbide?

I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.

02 August 2024 6,789 4 View

Z-average size from Dynamic Light scattering can it be lower than the original probe size?

Hi everyone, Recently I have been conducting Dynamic Light scattering experiments in a micellar solution at 5 and gel at 37 degrees of Celsius with latex particles of diameter 190-500 nm. While...

01 August 2024 1,168 4 View

Ti6Al4V - Phase differentiation between alpha and alpha prime martensite?

Dear Researchers, Is it feasible to distinguish between alpha and alpha prime martensite in the Ti6Al4V alloy under rapid solidification in the as-cast state using XRD, in addition to...

30 July 2024 3,849 0 View

While doing Chronoamperometry, when the light is turned off, why the current is not decreasing sharply?

Here, I have used Ag/AgCl as reference electrode and 0.5M KOH.

29 July 2024 4,538 3 View

Aqua regia not heating up?

I used Aqua regia to clean Au nanoparticles in the used glassware. But for some reasons, it is not heating up upon mixing. The color did change from no color to light orange. The Au NPs on the...

25 July 2024 4,390 0 View

I found the zeta potential of exosomes in DLS and it was -8mv. So is it correct or not ?

What should be the zeta potential of bovine milk exosomes

25 July 2024 7,376 5 View

Comparing Liposome Size: DLS Measurement vs. SEM Observation with Air Drying ?

I have an issue with SEM imaging of liposomes. When measured by DLS, they appear to be around 120 nm, but when using SEM with simple air drying, they appear much larger, around one micrometer.

25 July 2024 3,395 3 View

Can anyone kindly suggest research topics in the area of thermodynamics, heat transfer, fluid mechanics or renewable energy?

I am an undergraduate mechanical engineering student seeking suggestions on topics related to either thermodynamics, fluid mechanics, heat transfer or renewable energy for my final year project....

24 July 2024 4,058 5 View