Why positive semidefinite state penalty matrix in LQR and LQT problems?

Why the state weighing matrix is taken to be positive semidefinite and not positive definite in optimal control problems - like LQR(Linear Quadratic Regulation) and LQR (Linear Quadratic Tracking?

07 August 2018 2,636 3 View

Which sensors are generally costly in Aircraft systems?

Accelerometer or pitch rate sensor Which sensor is more expensive? Can anyone tell or give a suitable paper or document?

10 November 2017 1,738 1 View

Second order linear equations?

Why is it not possible to obtain a continuous open loop control u(t) such that each solution of y''+y=u(t) approaches the origin as t approaches infinity independently of initial conditions? I rea...

05 June 2017 7,855 2 View

Differential algebraic equations?

Why do we go for differential algebraic modelling of dynamical systems when we can solve the problem algebraic equations as constraints to a simple differential equation (the state of art for...

03 April 2017 8,887 5 View

n linearly independent solutions of a nth order differential equation?

How do I prove that a nth order differential equation has n linearly independent solutions?Also, how to prove that there is no possible solution other than those covered by the linear combination...

07 August 2016 4,939 10 View

How softwares and hardwares work?

We all work in an environment where we use computers extensively for carrying out research.But i believe that not many know the actual interactions between the software and hardware,I want know...

31 December 2015 2,643 2 View

How can the gate to source voltage in a nMOSFET can atract electrons from heavily doped n regions when it is vertical ?

The gate to source voltage in a nMOSFET is vertical. Then how can it attract the electrons in the n region because the electric field associated with it is vertical and does not apply to those...

01 February 2015 3,478 6 View

How to start writing a research paper?

I want start a original work on calculus.How should I begin?

31 December 2014 3,746 2 View

Books for control systems

Please suggest best boks for studyibg control systems engineering.

08 September 2014 1,603 9 View

Research

Which is the best research institute in India for signal processing? I am currently pursuing Maters of Electronics and Communication Engineering and want to know the procedure to enrol in research...

07 August 2014 6,961 2 View

error in running a model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

error in modelling model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MGL tools

20 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

what is the simplest definition of ion exchange capacity

What this unit identifies for the ion exchange capacity ca. 0.92 meq. g-1. I am a newcomer in the membrane area. I just started. I highly appreciate your help

08 May 2021 0 0 View