8 Questions 6 Answers 0 Followers
Questions related from Vibhu Sharma
Dear researchers I am investigating the effect of slurry concentration on ca6nm substrate steel for erosion rate. My test rig is slurry-jet type. Parameters are slurry concentration, slurry size...
04 April 2018 280 2 View
Hi I am doing ball milling for transforming Tio2 anatase compound micron powder into nano powder. after XRD test it is found that The anatase phase of tio2 is transforming into the rutile phase...
09 September 2017 6,775 5 View
Dear all i was trying to produce Ti02 nano particles in high speed ball milling machine. my initial setting was 400 rpm 6:3 start stop time and ethanol and stearic acid were used as PCA. After 9...
08 August 2017 7,648 2 View
i want to fabricate tio2 nano particles via planetary high speed ball milling process. initially i am taking a 40 micron particle size. please suggest the RPM i could set and what PCA i should...
08 August 2017 6,761 1 View
Dear Friends. I am new user of DLS Test for measuring the size of nano particles i have made by ball milling machine. i am attaching one of picture of my DLS result. plz tell me how to interpret...
08 August 2017 8,423 10 View
i had prepared a Al2O3 nano particles by Planetary ball milling process. The SEM images show the lumped particles therefore morphology of particles is not much clear. somebody suggest to make a...
05 May 2017 1,906 11 View
I am synthesis the Al2O3 in planetary ball milling machine for reduction of particle size. After 3 batch of 9hr process for 25grams Al2O3 the time has been increased from 9hr to 12 hr. Why this is...
12 December 2016 5,356 7 View
firstly, i want to know that what particle size of Al2O3 initially i should take for ball milling. Secondly, i want to know that is that there is possibility of contamination if i make 70-80 nm ...
06 June 2016 2,792 9 View
