8 Questions 3 Answers 0 Followers
Questions related from Unnikrishnan Bm
1.A steel plate is used to distribute the load evenly to concrete, how to connect the plate(shell) to concrete(solid ) 2. I have to connect two parts (both solid and same material)which should...
04 July 2015 6,082 2 View
The tensile damage parameter, dt is defined as the ratio of the cracking strain to the total strain. Similarly, the compressive damage parameter, dc is defined as the ratio between the inelastic...
18 March 2015 8,720 19 View
In a RC beam with CDP model i included field output request as E for total strain, however while getting the output i'am getting the LE output only which is the "logarithmic strain".Is it because...
13 March 2015 4,470 4 View
In my RC beam with CDP my discrete model is not converging, can you suggest some reasons to improve, reinforcement and concrete are meshed such that they share common nodes? is it necessary to use...
04 March 2015 3,290 5 View
Please refer the attached paper, is it possible to obtain crack pattern directly for flexure without using any specialized techniques in abaqus just by applying loads exceeding the capacity
17 February 2015 4,752 5 View
Have you come across this error-"DURING THE CONVERSION FROM CRUSHING TO PLASTIC STRAIN Abaqus FOUND NEGATIVE AND/OR DECREASING VALUES OF PLASTIC STRAIN. VERIFY THAT THE DEGRADATION DATA UNDER...
16 February 2015 7,761 12 View
Dear Sir/Madam, Kindly help me with following 1.Can we create a concentrated load by creating a reference point and making it "active" in analysis.If so how to make a reference point active in...
16 February 2015 2,617 7 View
i modelled a RC beam with concrete damage plastcity characteristics with udl,Kindly help me as to how to find out the load deflection curve. Is it possible to monotonically increase the load to...
08 December 2014 9,380 4 View
