7 Questions 21 Answers 0 Followers
Questions related from Ramanathan Kanniappan
For ductile material normally Von Moises stress in analyzed in ANSYS for brittle material what kind of analysis should be done in ANASYS?
11 March 2014 3,677 16 View
How to find that, for an analysis, the model is failed in FEA if any experimental value data is obtained?
06 February 2014 6,636 6 View
I want to validate 3 point bending test in ANSYS workbench. I am considering isotropic material, so while giving the Young's Modulus Value should i give the flexural modulus value or Young's...
05 February 2014 4,225 1 View
I want to analyze tensile simulation in ANSYS (APDL), for that the data I have chosen is linear isotropic material Young's modulus, Poisson's ratio and density. I have two volumes, for both...
15 December 2013 1,670 5 View
At present I am facing meshing problem in ANSYS (APDL) I don't know why. I reduced the model to 1/4th and tried for meshing but the problem persists. So I am going for 1/8th and I have not tried...
08 December 2013 9,169 3 View
I am modeling two volumes in ANSYS like matrix and reinforcement. I was informed to use contact manager like surface to node where target and contact surface are to be chosen. What is the purpose...
27 November 2013 6,348 6 View
I am modeling a circular plate of 1 mm diameter and thickness of 0.1 mm and when I do the meshing, the ANSYS closes automatically, so I want to know: does the thickness create any problem in...
26 November 2013 5,724 9 View
