Parth Panchal

6 Questions 15 Answers 0 Followers

Questions related from Parth Panchal

How to eliminate or reduce the leakage between rotor stator geometry in FLUENT ?

Hello All, I need a small help for my CFD simulation of combustion in Fluent. I am working on a rotary engine which has one rotor and a housing. I am using dynamic mesh while rotor rotates within...

18 February 2017 8,741 8 View

Can somebody help me with CHEMKIN auto ignition Problem ?

Hi there, I am having a simple box geometry (2D). I am using a reduced CHEMKIN mechanism for n-heptane for the combustion purpose. The initial conditions are as follows. Initial mixture mass...

05 December 2016 3,478 5 View

Can Species model in the Fluent be used for modelling the diesel combustion ?

Hello there, I am working on a rotary type IC engine having diesel injector. The simulation is unsteady with the flow and with DPM for diesel spray. I just checked mixing of Air and Fuel by using...

07 October 2016 7,725 10 View

How can I restrict the mass flow by using Interface in dynamic mesh in ANSYS FLUENT ?

Hello There, As I mentioned in my previous question, I want to eliminate the leakage between rotor and stator. There is a small gap between rotor and stator surface. I am using dynamic mesh and I...

30 August 2016 598 3 View

Is there any solution to eliminate a gap between stator and rotor in wankel engine while simulating for a combustion ?

Hello there, I am working on a simulation of a rotary engine ( Similar to Wankel engine). The situation is as below.The stator is steady and rotor is rotating at 580 RPM. I am using dynamic mesh....

17 August 2016 9,248 5 View

Convergence issue with using DPM in fluent ?

Hello there, I am working on the spray modelling with the fluent. Using DPM model for unsteady particle tracking of diesel-liquid with the unsteady continuous fluid as air. Before the injection...

07 April 2016 8,577 8 View