8 Questions 19 Answers 0 Followers
Questions related from Nikesh Bhattarai
As we know there are numerous components and systems in Ansys workbench, such as Ansys Fluent, CFX, etc etc. But I only want to perform static structure analysis and want to buy a package that can...
10 October 2016 7,155 4 View
Cart3D Tool in ICEM CFD Ansys 14.5
07 July 2015 3,570 1 View
I am thinking of simulating the flow of water on a tank through holes at the bottom. It can be hand calculated to estimate the time required to drain out the water but I want to do some CFD on...
04 April 2015 5,651 9 View
I am trying to find if there is an analytical or simpler way to find pressure or force acting on the upper surface of a wing due to the gust wind. Assuming the wing is not in motion (static case)...
02 February 2015 2,566 5 View
I'm trying to simulate flow through a regulator to check at what position the outlet has 1000 psi (Fig attached). The inlet pressure (static) is 2,800 psi. I can measure experimentally the static...
01 January 2015 9,544 13 View
I am trying to think of simple general modifications that can be done to a conventional type UAV so that it flies with better stability during crosswind of about 13m/s.
01 January 2015 2,798 13 View
What is a floating boundary condition in CFD? In what condition can I use it? I suppose such a BC exists only in few commercial packages. Are there any other BCs equivalent to a floating BC in...
09 September 2014 6,919 5 View
I have a case where I need to perform some CFD simulations. There is a mixture of water and sludge in a water reservoir which flows through a pipe installed at the bottom and then past a...
08 August 2014 8,236 24 View