10 Questions 19 Answers 0 Followers
Questions related from Kumar Ujjwal
Hi, I use ANSYS APDL for additive manufacturing simulation. Since I loop the ealive command to apply thermal load, I cannot use the LSWRITE command to write the load step. When I try to animate...
02 February 2024 7,987 1 View
Hi, I am trying to transient thermal analysis where, based on the temperature of a specific node, I want the code (shown below) to decide the value of the thermal load. However, I am getting a...
21 January 2024 8,740 3 View
Hi, I am trying to model the WAAM (wire-arc additive manufacturing) process in ANSYS APDL. The solution didn't throw any errors, but the result is a bit confusing. The graph in the figure is node...
04 May 2021 7,869 3 View
Is there a way to control the order in which the elements get numbered in ANSYS APDL? As shown in the figure, I want the element just above element 10 to be numbered 11 and the element next to...
02 May 2021 3,376 5 View
I am trying to model the below heat flux distrubution profile in ansys apdl. The heat flux is varying radially as given by the equation. I want to apply this distribution to the selected nodes in...
24 October 2020 586 1 View
Hi, I have imported model from solidworks and glued all the volumes. while meshing i got warning that i have attached. I am trying to move the circular heat source along z-axis from one end to...
13 October 2020 2,350 4 View
Hi, i am trying to simulate multilayer metal deposition using 'element birth and death' technique. I have glued the three volumes ie substrate, layer1,layer2 as shown in figure. Then, i am trying...
16 September 2020 3,785 4 View
I am beginner inLAMMPS and trying to simulate GTAW wire deposition additive manufacturingby implementing SPH(Smooth Particle Hydrodynamics)in LAMMPS , i have already gone through "...
27 July 2020 8,262 0 View
Hi, I am trying to model metal deposition by the welding process. The results from the previous load step will be the initial condition for the next load step. Following are the step adopted for...
01 January 1970 5,023 5 View
I am working on laser cutting of CFRP(carbon-fibre-reinforced polymer) composite. Based on the experimental data, I have modelled the laser cutting of the CFRP composite sample in ANSYS APDL. I am...
01 January 1970 6,527 3 View
