Jeevan T.P.

6 Questions 8 Answers 0 Followers

Questions related from Jeevan T.P.

Why thrust force, temperature and surface roughness increase with feed rate in Machining?

Reasons why thrust force, temperature and surface roughness increase with feed rate in Machining?

18 November 2020 1,142 4 View

Is there any testing methods available based on ASTM to know anti corrosion ability of cutting fluids in machining?

Need to know the micro-organisms that can grow in metalworking fluids (Vegetable based and commercial mineral oil based) after machining. Uncontrolled microbial growth in cutting fluids after...

09 January 2017 5,634 3 View

Is it necessary to study friction and wear characteristics using pin on disc tribometer , even after knowing the viscosity of Biolubricants?

Just by knowing the viscosity of biolubricants is it possible to judge the performance with respect to friction and wear characteristics. (Does lubricant with higher viscosity gives better...

12 October 2016 3,174 13 View

Cutting Tools recommended for machining SS 304L?

Cutting tools best suited for turning and drilling SS304L to study tool wear behaviour with Minimal Quantity Lubrication environment.

01 January 1970 2,028 3 View

How to select the machining parameters (Speed, Feed & depth of cut) for turning and drilling AISI 304L to evaluate tool (Carbide) wear behavior?

On what basis I can select the machining parameters for determining tool wear during turning and drilling of AISI 304L with carbide tool.? Is there any data hand book available to select these...

01 January 1970 5,366 6 View

How to check the anti corrosion stability of vegetable based cutting fluids? Any standard tests or methods available for the same?

Machined components after being finished working is exposed to different kind of atmosphere conditions. How can one make out the anti corrosion stability of vegetable based cutting fluids on the...

01 January 1970 2,539 3 View