8 Questions 14 Answers 0 Followers
Questions related from Deval Vyas
I am interested in drilling approximately 0.2mm diameter micro hole array in ss 304 substrate. Is possible to use commercially available syringe needles made from ss 304 or ss 316 as electrodes...
20 December 2024 1,016 0 View
Say there is an elastomer strip of length L, width W and uniform thickness -T. All other parameters like material density, temperature are constant. I mark this strip with N points starting...
26 October 2018 900 3 View
I am looking for ways to attach a transparent plastic film to a transparent glass using a transparent medium or transparent glue. Is there any way to permanently glue or laminate any plastic film...
08 November 2017 7,543 4 View
I am looking for fast drying inks that that be completely removed without leaving any traces or ghosts behind by just dipping the substrate in ink remover. I am not able to apply any sheer force...
11 June 2017 1,858 2 View
What is the best way to coat the inside of a plastic tube with pigments? I was thinking on lines of coating the inside of plastic tube by pushing fast drying solvent based liquid pigment ink...
29 May 2017 7,191 6 View
I am looking for foolproof method of filling and retrieving fluids from a wide micro fluidic channel. The channel height is 100 microns but width is around 10 cms. Can some one please guide me...
27 March 2017 1,509 9 View
I am looking at increasing the aspect ratio of photo-chemically etched micro holes. The aspect ratio of photo-chemical etching is usually 1:1 where as I am looking at 1:5 to 1:10 aspect ratio. So...
17 September 2016 2,203 2 View
I need help in calculating the total pressure required to move droplets in a micro channel network with constrictions. I am moving 100 droplets in a micro-channel which also has 100...
21 March 2016 3,529 2 View
