Arsalan Ahmad

12 Questions 9 Answers 0 Followers

Questions related from Arsalan Ahmad

Whic step is good in Abaqus to model the incremental load behaviour, Explicit or Static?

I am modelling Hydraulic plunger load on the pipeline. the load variation is linear over the time. I am using Explict step eith linear amplitude curve for a certain time period. The problem with...

21 December 2020 1,041 2 View

What are suitable step to reverse motion of drill bit during dental implant in abaqus ?

Hello every one. I am working on modelling dental implant and need some guidelines. I have completed the initial step for implant which is to create cavity inside a jaw. For this i have used 4 mm...

11 October 2018 1,254 4 View

To analyze the heat transfer in cement kiln which software is best ABAQUS orANSYS ?

Hello everyone. I want to simulate heat transfer in cement Kiln and to analyze different modes of heat transfer including convection , conduction and radiation. I know ABAQUS is capable of...

06 September 2018 463 3 View

To model fatigue which option should be best Fe safe or ABAQUS?

i want to model fatigue for buried pipelines.Please tell me which software should be best for modelling

06 August 2017 372 3 View

To model low cycle fatigue for buried Pipeline which additional properties should be defined apart from elastic ,plastic and density ?

Hello every one .Hope you will be fine i want to model low cycle fatigue in ABAQUS for buried pipeline .Please guide to model during modelling in material section which additional properties...

30 July 2017 3,522 3 View

How to apply incremental load in abaqus with load maintained for 2 minutes at each increment to monitor structure?

Hy every one i want to load the wall incrementally with rate of 0.4 kN/s. i want the load to be maintained for 2 minutes at each increment to monitor the doformation of the structure .[lease guide...

19 June 2017 9,001 6 View

Speed to wave deformation error of certain node in abaqus ?

Hello every one . i am modelling the soil pipe interaction in abaqus .I have done non linear analysis of pipeline crossing strike -slip fault and normal flexure load but when i off the non...

07 May 2017 2,355 1 View

How to model high cycle fatigue in abaqus ?

Hy i am working on the Fatigue analysis of buried pipeline .I want to model high cycle fatigue in abaqus.Can any body tell me how to model it and please tell me the significance of paris law in...

16 March 2017 4,845 1 View

How to model number of cycle at certain speed for the certain load in abaqus ?

I have a car moving with certain different velocity on the concrete specimen and i am moving it forth and backward for definite number of cycle?Will you please tell me that during modelling in...

13 March 2017 3,131 2 View

How to find elastic modulus of soil by direct shear test ?

i have done direct shear test on the low plasticity silt soil and in the result i have found value of cohesion,friction angle ,and mass density as well as bearing capacity.IS there any method to...

12 March 2017 5,560 8 View

Can Change in thickness of X70 steel pipe has an effect on its stress strain curve?

I have read some where that thickness has no effect on the properties of steel i.e young modulus ,tensile strength etc. If it is true than why thickness has no effect on properties of steel ? I...

01 January 1970 3,362 2 View

What is difference between gravity and Body force in abaqus ?

i am trying to model the stress variation in underground pipeline under traffic loading .i am trying to define the self weight of body so when i used the body force the result is different and...

01 January 1970 653 4 View