Arbab Faisal

9 Questions 25 Answers 0 Followers

Questions related from Arbab Faisal

Is it possible to calculate the mass of the steel building by using the accelerometer data?

I tested a 5 story steel frame on a shake table. but I forgot to calculate the total mass of the building. Can I calculate it by using the accelerometer data? if yes, Please help. Thanks

04 April 2018 5,083 3 View

How can we derive a formula using gene expression programming?

I have Matlab code. But I don't know how to derive formulation using GEP or this code?

10 October 2017 4,752 2 View

How to make sure that concrete is properly compacted in concrete filled steel tubes?

I just casted concrete filled steel tubes. In order to avoid segregation, I tilted the tubes at approximately 60 Degrees and then insert concrete inside. Now is there any kind of test for making...

08 August 2016 2,864 21 View

Filling of hollow steel beam with concrete

I want to fill rectangular hollow steel beam with concrete. The problem is that length of the beam is 3m. Can you give me some suggestions on how to fill it vertically? As throwing concrete from...

06 June 2016 7,921 5 View

How can i design concrete filled steel tube in ABAQUS?

For Research purpose

06 June 2015 5,327 7 View

How can we compare the load-deflection curve of two beams having same cross-section and different length?

If we have two beams having same cross-section and boundary conditions but different lengths. How will we compare their load-deflection curve? Or in simple words, how to convert the...

01 January 1970 9,385 16 View

How to calculate the yielding stress in concrete filled steel tubes?

Recently I tested concrete filled steel tube of 3.5m length for flexure load. When the maximum deflection at the center reaches to 20mm, the machine broke down. Now I want to check that whether...

01 January 1970 4,064 5 View

How to draw moment-curvature curve for composite beams when load-deflection curve of the beam is available?

I performed experiments on Concrete filled steel tubes. Got the results in the form of load-deflection curves. Now, I want to convert them to moment-curvature curves for the purpose of comparison...

01 January 1970 7,186 12 View

Will there be any difference in stress-strain curves of concrete cylinders and cubes?

If we use concrete cubes instead of concrete cylinders for finding the stress-strain curve, what effect it will produce? Will both be the same or will there be an effect of h/d ratio?

01 January 1970 3,960 10 View