6 Questions 13 Answers 0 Followers
Questions related from Aniruddha Sanyal
In terms of CFD, we often analyze the stability of the error using Von-Neumann analysis, especially for FDM based problems. Should we follow the same approach for a compressible fluid flow using FVM ?
14 July 2024 6,246 5 View
While deriving for a momentum equation with elastic stress effects, I am planning to put a ratio between elastic modulus (in Pa) and dynamic pressure (in Pa) in a simplified form. I am not...
24 June 2024 7,912 1 View
Is there any article that provides good insight on the procedure for reaching an analytical solution of this problem, especially when heat is applied at the wall of the cylindrical pipe and the...
05 March 2020 9,238 7 View
What is the value of velocity which ANSYS takes up while it calculates drag or lift coefficients when a fully developed flow, involving power law fluid, enters inside a parallel plate. Is it the...
08 February 2019 262 2 View
I am trying to implement CBC in ANSYS Fluent at the outlet. Please guide me through. I have written a single UDF where I have defined a parabolic profile at inlet and a CBC for the outlet. When I...
30 December 2017 4,926 2 View
For a non-isothermal compressible flow (highly viscous fluid) through a channel, I am getting spatial temperature values almost up to 10% elevated from the maximum value of temperature which has...
01 January 1970 539 9 View