You have requested to follow the project. but without seeing some details, its difficult to follow

24 July 2017 0 5K Report

Badges
Science method

More Saipun Shaikh's questions See All

Hi. How can I carry out mediation analysis on AMOS without all items loading onto each construct? Should I calculate the mean and proceed?

Hi, I am trying to run mediation analysis on AMOS. In the tutorials there are no items loading onto a factor which is not the case for the development of a measurement and structural model. How...

23 October 2020 4,240 8 View

How to detect Methanogens using Flow Cytometry from wastewater?

Hi everyone! I'm trying to identify methanogens from wastewater using flow cytometry . Any idea on how to go about it? which stains or flurochromes we have to use? how do we go about isolation of...

24 June 2020 3,906 4 View

What is the difference between spark plasma sintering and electric resistance sintering?

It is well known that plasma sintering is based on the electrical spark discharge phenomenon for preparing high-density composites at lower temperatures and higher sintering speed. How it differs...

03 March 2020 4,458 4 View

Plasma Nitriding with hollow cathode discharge?

We have a cathodic arc PVD system which uses hollow cathode arc (plasma) with Ar as a prior cleaning step. Now our idea is to use this set up for plasma nitriding of SS 3xx series. The plan is to...

06 February 2020 5,596 1 View

Questions regarding adapted questionnaire?

I HAVE FEW QUESTIONS REGARDING ADAPTED QUESTIONNAIRE. IF ANYONE KNOWS ANY OF THEM, PLEASE ANSWER is it necessary to adapt from some journal's article? or we can adapt from thesis or review...

09 November 2019 6,303 6 View

Is there a possibility of Microcarburizing environment in graphite heating furnace?

I am planning a sintering experiment for an Fe-Si system. I have a high temperature furnace with graphite heating elements. I am concerned if there's a risk of carbon pick up due to prolonged...

28 August 2019 2,927 1 View

Photoelectrochemical study of CdS, CdTe and CdSTe thin film, which electrolyte i must use and which must be the counter electrode?

I have prepared CdS, CdTe, CdSTe tgub films and now doing its PEC study. I tried it with polysulphide electrolyte but the Isc and Voc obtained was very less than expected. again I tried with...

13 August 2019 6,727 4 View

Can anyone explain how to identify phyto-constituents present in water soluble extract?

I have successively extracted leaf powder with Pet. ether, benzene, chloroform, ethanol and water by using soxlet apparatus. Out of this, my water extract showed highest activity. Preliminary...

13 June 2019 1,153 18 View

How much is the conversion efficiency of an RF energy harvesting scheme. Further, what is the impact of number of antennas ?

I would like to know that how the number of antennas impact the total harvested energy. Further, I would like to know if this would also impact the power conversion efficiency?

14 April 2019 5,814 6 View

What are Nonlinear Models for RF Energy Harvesting ?

Can anyone help me out in understanding the nonlinear models for RF energy harvesting. Specifically, I would like to know the impact of multiple antennas on the amount of harvested energy. How...

14 April 2019 6,613 3 View

Should the AUC in a concentration-time graph of a subcutaneous implant be roughly the same for poeple?

I have 2 concentration time curves of a subcut drug implant. the first group has a peak around the 50 day mark where as the second group does not. Both groups received the same implant by the same...

10 February 2021 2,305 3 View

How to perform CV by using potentiostat?

I have deposited a metal oxide thin film of glass plate, A conductive thin film was also deposited on the glass substrate before the deposition of metal oxide film. How can I perform its CV from a...

01 February 2021 7,710 3 View

How to conduct Methodological Research?

Hi everyone, I plan to create a design for a system using previously published articles, journals, etc as a basis. I found methodological research design but I don't know how to conduct it. Like...

07 January 2021 5,824 3 View

How do I interpret fit statistics SEM and Modindices output?

Hi, I would need some help in understanding the SEM output. I run a latent change score analysis to test the change score of a variable of interest at two-time points (repeated measure) PLD1 and...

05 January 2021 3,367 2 View

Can you give me some Information about the generation of ROS in marine surface water?

Reactive oxygen species is a very new term i think

23 December 2020 8,416 4 View

How to measure knowledge/competence gap in IT outsourcing?

Hi all, I am currently writing my master thesis about the knowledge/competence gap between an IT outsourcer and his client. By this I mean the difference of the IT knowledge and the impact that...

20 December 2020 9,228 7 View

How to include two different molecules in one Crystal Information File and define the hydrogen bonds between them?

Hello everyone, Please help me to create a CIF with two different molecules which are linked through hydrogen bonding in the same crystal lattice. I am attaching an example to understand what I...

16 November 2020 8,056 3 View

How is the quality of archived blood sample for HbA1c test?

HbA1c is an important indicator of long-term glycemic control with the ability to reflect the cumulative glycemic history of the preceding two to three months. Also, HbA1c is measured as the ratio...

16 September 2020 2,423 4 View

Any suggestion in Masters thesis topic for Information & Communication studen ?

I am student of Mater in Information & Communication engineering . Please suggest me the thesis topic as I am unable to decide it....

12 September 2020 2,344 3 View

Does any one has information on chemical toxicity (Y-axis) and its relation to chemicals dose (X-axis). Can we apply LNT model or any Threshold model?

Does plot of chemical toxicity (Y-axis) and its relation to dose (X-axis) is linear obeying LNT model or we have to apply Threshold model for doses response of chemicals. Information on any...

12 September 2020 5,220 5 View