I have set everything up according to the guide provided by Molecular devices, and according to them, if the lab bench and the telegraphed instruments are set properly, clampex should automatically know when I switch between voltage and current clamp recording mode. I am not sure why but in my voltage and current clamp recording protocols, all primary and secondary inputs (Im_prime and Vm_sec for voltage clamp, Vm_prime and Im_sec for current clamp) are set at pA unit always. Does not matter if I change mode between current clamp and voltage clamp in Multiclamp 700b commander. I am sure it is a naive mistake, but can anyone help?
Instruments: Digidata 1440a, Multiclamp 700b.