the simulation in abaqus explicit completed but surprisingly when I click U,S, DamageT, DamageC or something, else everything is zero (below screenshot). any thoughts would be highly appreciated.
i also added my CAE file.
Hello! Did you select the field output or history output? If you use a material subroutine then the status SDV should be selected, too.
As monitor shows, the stable time increment is equal to time period of the step. Therefore, analysis is completed in one increment. I recommend to select Value (for example, 0.00018) instead of Unlimited in step-1 incrementation tab.
Victor J. Аdlucky hi, Based on ur explanation, I had play with instead of Max. time increment but still the same. for your information, Kinematic energy is 0. I have attached my CAE file. if possible can you check it? It will be very helpful and highly appreciate
Changfang Zhao
Yes, I did but still the same. if you have time you may check my CAE file. I have attached it. for your information, my Kinematic energy 0. It will be very helpful and highly appreciate
Hi Mahmudul Hasan, I obtained nonzero KE when chosen max time increment as 0.1 of time period. Of course, it may be too large increment.
Victor J. Аdlucky thank you so much for your help. May I know why I can not see my Damagec and DamageT? Do u have any idea about it?
Mahmudul Hasan Since length unit is mm, mass densities should be reduced by a factor of 109.
- Badges
- Science method
- Similar topics
- Methodology
- Crystallography
- X-ray Diffraction