Adherance of Polyaniline coating over stainless steel?

Is the electropolymerisation of polyaniline coating over stainless steel (SS) via Cyclic voltammetry technique is really adherant? Else how to improve the adhesion of the coating, whether any...

01 March 2021 8,220 2 View

Is there a way to identify the clay mineral based on the Si:Al ratio that has been obtained through EDAX analysis?

I have come through a few literature,were the presence of particular clay mineral has been validated through the Si:Al ratio obtained from EDAX analysis. But, I would like to understand the basic...

08 January 2021 5,982 6 View

What are the application of graph theory to fluid mechanics?

What are the application of graph theory to fluid mechanics? Kind help if any papers kind help Any relation to 1) distance in graphs 2) graph coloring 3) graph Decomposition Or any other fields...

08 November 2020 9,974 3 View

Could ultrasound produced by bats protect them from coronovirus?

18 April 2020 7,990 3 View

In LES non-premixed combustion of propane-air in Ansys fluent, there is no signs of combustion. The temp. is 300K everywhere. How to overcome it?

In LES non-premixed combustion of propane-air in Ansys fluent, there is no signs of combustion. The temp. is 300K everywhere. How to overcome it?

05 April 2019 9,809 12 View

What could be the possible reasons to not achieve mass balance in assay and RS methods of a drug solution packed in LDPE ampules?

Upon stability, the assay reduces to 91 to 92% but the remaining 8 to 9% is not being compensated by impurities. Assay and RS, both methods have been developed using HPLC. To identify...

21 January 2019 2,576 4 View

Giemsa stain - are these macrophage nuclei or myelocyte-blast nuclei ?

The picture attached herewith is giemsa stain of mouse liver - i wish to know if these nuclei that are seen are that of macrophage or myelocyte -myeloblast or basophil or mast cell ?

11 December 2018 1,141 1 View

Which inforcement in the MMC increases the electrical conductivity and reduces thermal expansion??

I want to know which inforcement in the metal matrix composites increases the electrical conductivity of it. Also, state the reinforcement to reduce the thermal expansion. Kindly mention some...

31 August 2018 9,557 3 View

Can you send me articles related to 3D printing in metallurgy application?

I want do some research in 3D printing in the field of metallurgy

29 June 2018 9,771 2 View

How can we measure Shear modulus of Composite laminate ?

03 August 2017 1,188 3 View

Matrix based scientific data analysis: extrapolating to matrices of sets?

Data sets, when structured, can be put in vector form (v(1)...v(n)), adding time dependency it's v(i, t) for i=1...n and t=1...T. Then we have a matrix of terms v(i, j)... Matrices are important,...

30 January 2021 9,295 6 View

How can i remove the error bar from the legend?

xdata1=tempmeasS2.Timesec; ydata1=tempmeasS2.UCNP; plot (xdata1,ydata1) err2 = tempmeasS2.UCNP1; e2=errorbar(xdata1,ydata1,err2, 'b-', 'lineWidth', 1, 'HandleVisibility', 'on') legend ('1...

13 January 2021 3,140 3 View

Which is the most efficient at distinguishing graphs, complexity index or vector complexity index?

There are different ways to distinguish the graphs, for example, using the complexity index and also using the vector complexity index. Is there a study on the efficiency of the two methods?

26 November 2020 5,616 2 View

By which softwares may i draw some attractive figure for my research paper on Textile related fields ?

Some of the fugure are attached in this question. I want to know some software to draw figure as like as the picture attached. Also for graph drawing software if any without SPSS. Some figure...

06 October 2020 8,059 6 View

What's this isomorphism at play in quantum optics?

I have looked at the time development of the creation and annihilation operators for a mode of the quantized free electromagnetic field. It was assumed that the equations of motion for these...

29 September 2020 8,955 5 View

Help to produce graph in ORIGIN PRO?

Hi, I want to produce a graph in Origin, comparing two groups of data, in the form of scatter points, where the mean and SE bars are included. See attached photo for reference. It is simple to...

25 September 2020 9,756 1 View

Which softwares are useful in graph theory and in particular in spectral graph theory?

Path Eigenvalues and Path Energy of Graphs

19 September 2020 8,258 7 View

No title

Dear peers, I am working with extinction models in interaction networks using the bipartite R-package. I can determine the order in which species will be removed based on abundance and degree or...

30 August 2020 2,351 2 View

Do the deterministic polynomiality and non-polynomiality characteristics of this method prove efficiency?

Dear Researchers, I proposed a new method, called Optinalysis, for symmetry detection, similarity and identity measure between two automorphic or isomorphic graphs. I tested the method using the...

10 August 2020 5,020 1 View

Any suggestion on R Packages or Codes for plots like Severity-Frequency?

I would like to create a graph where it looks like the pictures attached below using R software. Is there any packages or codes that can help me do it? First picture was hand-drawn. Second...

29 July 2020 4,779 2 View