I have a case report in dermatology. Which journal is suitable?

31 December 2015 4,601 1 View

Is there a researcher who uses my method to obtain the neutrophils?

Heparinized whole blood in sterile injector must remain in a sterile incubator with 5%CO2 for two hours, vertically. Injector needle must be bent at 90 degrees. After two hours, top level must...

03 April 2014 8,382 1 View

How many islets must be included this artificiel pancreas ?

Standartisation of islets and insulin secreting for children must be done.

01 January 1970 5,893 0 View

If diabetics dont exhaust so excessive water with urine blood glucose will be diluted isnt it?

01 January 1970 6,206 1 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

How Can I clain a removal of a co-author?

I would like to make a correction in a co-author in your paper which is wrong. This name is also in other papers of Kenton Ko. Zey Ko is not a Co-author . The correct name is Zdenka...

24 February 2021 3,476 4 View

How does the injection volume impact LLOQ and ULOQ in regression analysis (LC-MSMS)?

Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...

23 February 2021 9,159 3 View

Difficulty in debugging code to correct error - TypeError: '<' not supported ?

I am trying with a Unet code ontained from net ...in tensorflow. When trying to predict the segmentation result with the trained and saved model with metric " iou" using "CustomObjectScope"...

22 February 2021 5,254 1 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View

How to perform Haldane correction on SPSS?

I was wondering if anyone knew how to perform the Haldane correction for SPSS (this is the definition of the correction -...

21 February 2021 2,882 1 View

How to perform EEG classification of Alzheimer and control groups?

I am doing a project on classification of EEG signals of Alzheimer's disease and control groups. Previously, I extracted the alpha power of the EEG signals and found out the strengths. I want a...

18 February 2021 8,502 2 View

Why use both bead beating and enzymes (lysostaphin and lysozyme) for DNA extraction from sputum samples?

Hello, I have read in a few publications that to extract total DNA from sputum samples, both bead beating and enzymes are used to disrupt the cells. Bead beating is supposed to be efficient in...

18 February 2021 3,360 2 View

absorption= 1-mag(S(FP1:1,FP1:1)*S(FP1:1,FP1:1))-mag(S(FP2:1,FP1:1)*S(FP2:1,FP1:1)) is it correct for absorption ?

hi everyone I am simulating a unit cell structure in HFSS using Flouquet port having two modes for absorption I have used this formula:- absorption=...

17 February 2021 9,178 2 View