Could anyone kindly provide the name of Institute/testing centre and contact details if any in India for TGA of Char in CO2 enviroment .
TGA facility is available at so many places like IITK,IIT-B , IIT Roorkee, NCL pune etc.you can go through their website and contact them for details reagarding TGA facility.
Chirag Goel have you contacted all of the above mentioned? if No ...do try to contact
Apart from IISc bangalore, Institute of chemical technology(ICT) Mumbai and National Chemical Laboratory (NCL) Pune also have the specified facility
Solid state and Structural Chemistry Unit, Indian Institute of Science, Bangalore
Inorganic and Physical Chemistry, Indian Institute of Science, Bangalore
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 980 5 View
Hello everyone! I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...
05 August 2024 5,729 2 View
Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...
03 August 2024 5,358 0 View
need to open an account to upload my published papers
01 August 2024 9,255 1 View
All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.
01 August 2024 589 4 View
I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...
01 August 2024 9,227 1 View
Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...
30 July 2024 9,824 2 View
N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.
30 July 2024 7,233 4 View
Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...
30 July 2024 906 2 View
Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...
29 July 2024 7,198 9 View
I have different polymer solutions and I hypothesize that water molecules are retained based on the water-polymer interactions, so the amount of free water is less to intercat with drug tablet....
28 July 2024 9,545 6 View
Since BET and TGA both are very costly instruments and many places the facilities are not available (for large number of samples) hence a threshold degassing temperature and time is preferable
16 July 2024 8,112 2 View
I read it Convert the y-axis from mass loss to degree of conversion (100-x)%. What if tga analysis have residual char, for example at mass loss% 27% Is it the same eqation to get conversion...
15 July 2024 4,218 1 View
Usually TGA is performed either with Nitrogen or air which are purged through the system. Can this analysis be performed without using any of these purged gases? Also for air (80/20) is set by...
30 May 2024 7,679 3 View
I have also attached TGA and DSC analysis of biosynthesised nanomaterial.
30 May 2024 1,565 1 View
I'm trying to synthesize a highly polar compound which is uv inactive (In TLC charring at the bottom- 0.1RF/20%MeOH:DCM ,MP) . I have confirmed the compound by simple mass and H'NMR spectrums but...
22 May 2024 9,818 3 View
I analyzed cement samples exposed and unexposed to moisture over various periods. The TGA results of these samples showed variation with each repetition. However, I consistently used calcium...
22 May 2024 1,339 3 View
I have to calculate the carbon content present in the catalyst from the TGA plot. Does anybody have an idea?
17 April 2024 4,718 2 View
Hello I'm using COMSOL 6.1 Reaction engineering module. I'm modeling a reaction in the form of : A-->B+C+D+... the reaction describes the thermal decomposition of a solid material. I got the...
16 April 2024 5,672 3 View
Dear all, After checking DSC and TGA analysis for ZIF-8 samples, it was possible to observe an endotermic peak at around 50ºC, using DSC under N2, and a weight loss in TGA at around 38ºC and 125ºC...
04 April 2024 8,460 4 View