Hello,
I want to know how can I find and calculate at what condition scaling occur?
For example if I have a water that contain 25000 ppm Ca2+ and 500 ppm SO42-, does scaling occur at the surface of a heat exchanger at 60C, water speed 1m/s?
Thanks
Sometimes when I run parametric table of EES (sweep a variable) I have get unstable answer at some rages. For example for 0, 1, 2, 3 I get 10, 0.005, 9.5, 0.00000014 But when I don't use...
02 March 2019 1,625 6 View
Dear all, I have water, humid air and ammonia in a system and I want to do an exergy and thermoeconomic analysis. If I take the water at 25 and 1atm as a dead state, how can I calculate the exergy...
31 December 2018 7,044 5 View
Dear all, Can I find any simulation about MVR Evaporator desalination in papers or books like the following process? http://img.shbenyou.com/2014/05/1399392716Vo5Pdd.jpg Thanks
10 November 2018 378 2 View
Dear all, Why does scaling occur at boiling? (can we say that the maximum concentration increase at surface at boiling so scaling occurs?) If boiling does not occur, Does we have scaling at the...
10 November 2018 9,205 6 View
Dear all researchers, What is the best way to desalinate very high saline water (up to +180000 ppm) for the purpose of ZLD? Can we use MED, MSF or TVC? (I know the scaling formation, but is...
10 November 2018 1,091 3 View
Hi all Sometimes the flashing process are calculated with mass and balance equations like the following...
09 October 2018 7,184 1 View
Hi What is the physical meaning of "non-equilibrium allowance"(NEA) in water desalination? thanks
09 October 2018 4,947 2 View
Dear all Which book has detailed explanations about flashing process? Thanks
09 October 2018 228 17 View
Dear all researchers, I want to know that if I have an EES program, can i use it as a function of a MATLAB program? Thanks,
06 July 2018 8,115 7 View
Hi I want to know that which software is good to simulate all kinds of power plants & desalination systems? I want a very flexible software to simulate novel systems that are not common some...
04 May 2018 8,598 6 View
Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1
17 August 2021 0 0 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
20 June 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
The role of climate change influencing the human behavior as well as economics interest
01 June 2021 0 0 View