I need to know the formula of the Gaussian Beam used by the software CST studio, so that I can identify the problem. Thank you in advance.
26 January 2021 4,690 3 View
Dear All, Does anyone share the experience about the measurement of IGF-1 in cells? I tried several times for measuring the level of IGF in cells by using the cell lysate or medium. However, I...
08 September 2018 7,348 3 View
im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...
02 March 2021 2,246 2 View
Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...
28 February 2021 7,016 1 View
Hello everybody! I have a problem with developing a compact antenna for the 1MHz-5MHz frequency range. Tell me what type of antenna can be used and what books and articles to read to perform this...
27 February 2021 7,710 4 View
I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...
27 February 2021 4,218 7 View
When I run the job for TS(QST3) in gaseous phase, it was completed without any error. But when I add water in CPCM model it terminated with an error: Inconsistency: ModMin= 2 Eigenvalue=...
21 February 2021 3,198 2 View
Dear friends, I am a beginner at DFT calculation. I have done a structure optimization using DFT- B3LYP/6-31G*, Nevertheless, I don't know How to calculate the Atomic Polar Tensor (APT) in...
17 February 2021 9,082 3 View
Hello everyone, I want to perform some gaussian calculations and want to use Materials studio for my research work. Can anyone guide me how to get access to supercomputer resources in India for...
15 February 2021 8,264 3 View
Hi, whenever i use circular array i get this error "Waveguide ports must be aligned with Cartesian coordinate planes for the transient solver" Does anyone use circular array with waveguide ports?...
09 February 2021 3,609 8 View
I am having trouble setting up this problem in HFSS or FEKO. In HFSS, I've tried both FEM and FEBI-IE solvers. With FEKO, I've tried it's MoM solver and default settings. I am would like model...
09 February 2021 375 2 View
Dear all, Now I'm selecting FEM for design of metamaterials on NIR~VIS frequencies, and keeping 3 software: ANSYS HFSS, COMSOL with wave optics module, and CST STUDIO SUITE. Could you give me...
09 February 2021 9,517 2 View