What can be the synthesis process of Mn based alloyed quantum dots? Will it be same kind of process followed by ZnSe(S) alloyed quantum dots?
https://www.researchgate.net/profile/Alexander_Titov2
actually , it's depends on what you plan to prepare. ratio of mixing with temperature conditions .
Those method should work.
why Manganese based alloyed systems are less explored and why alloying is necessary?
Even if we synthesize metal ferrites as a bulk then is it possible to exfoliate the synthesized metal ferrites with any solvent exfoliation technique.
06 July 2018 9,660 4 View
I did not understand why Mn based alloyed quantum dot is not showing fluorescence even after refluxing for 13 hrs. Should I reflux for more hrs or should i change the compound of the Mn precursor...
07 August 2017 5,505 0 View
Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...
07 August 2024 9,563 0 View
How select composition for ods-high entropy alloys?
31 July 2024 2,795 1 View
Any suggestions with respect to etchant composition and holding time?
27 July 2024 6,925 2 View
The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...
27 July 2024 8,508 0 View
Thanks
22 July 2024 1,143 3 View
Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...
21 July 2024 2,476 2 View
Organic Synthesis. My student has been trying iodination of arenes (our goal is to iodinate p-phenylenediamine) following these literature procedures: 1. Synthesis 2004, No. 11, 1869-1873 using...
16 July 2024 6,630 1 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...
13 July 2024 9,003 2 View
Waspaloy is considered the benchmark alloy. Due to the different gamma prime solvus temperatures, we couldn't adopt the same double aging treatment. Can anyone suggest how to select temperatures...
13 July 2024 2,417 1 View