What type of interface is the rectifying interface frequently mentioned in semiconductor film devices ?

02 February 2012 0 4K Report

I am reading thre references and studying the knowledges of semiconductor films as well as the related devices. I have one question that is what type interface the rectifying interface is? Thanks!

Badges
Science topic

More Lunyong Zhang's questions See All

How large pressure can a qartz tube sustain ?

who can tell me about how large pressure a qartz tube often used for materials synthesis such as in chemical vapor transport can sustain at about 1000C? 1MPa or larger. Thanks.

08 September 2016 5,074 4 View

Review process of the journal of Progress in Materials Science?

According to the author guidance of Progress in Materials Science, we sent a scientific manuscript and CV of the first author about two months ago to an editor of the journal for evaluation if the...

06 July 2016 6,186 2 View

Can you give me some advice about the data fluctuation problem in the Hall resistance measurement using PPMS?

In our Hall resistance measurement using PPMS DC resistance model with four probe method, we always encounter a problem that the resistance data randomly fluctuates, so we must remeasured a same...

07 August 2014 1,565 8 View

The mobility determination when there exists anomalous hall effect?

It is well known that the mobility is always determined through standard Hall effect detection. For an ordinary Hall effect, that is easy to extract the hall coefficient. However, if the system...

07 August 2013 9,596 1 View

Why is the anomalous hall conductivity defined as -Rxy/(RxxRxx+RxyRxy) but not 1/(Rxy-Rxyoh)?

Where R notes resitivity, Rxyoh represents the Rxy part coming form the ordinary Hall effect.

06 July 2013 9,003 3 View

The magnitude range of the elastic scattering length and inelastic scattering length?

I hope to know in most common cituations , what range the magnitude of the elastic scattering length and inelastic scattering length is in at low temperature for a strongle correlated system as...

05 June 2013 7,445 6 View

How to treat the as received LaSrAlO4 and MgO substrates to get smooth surface with steps?

It is well known that a smooth substrate with step surface is important for growing epitaxial films. Recently, I encountered this problem on LaSrAlO4 and MgO substrates. I have tried H3PO4 etching...

02 March 2013 9,374 3 View

Could spin orbital coupling form in a perfect crystal without inversion symmetry structure?

In my knowledge, near all of the publications say the spin obtial coupling originates from the moving of a spin electron relative to a atom, and there are two mechanisms to induce SOC, i.e. the...

31 December 2012 8,708 2 View

Does anyone have the crystal structure data (CIF or other format) of SrRuO3 with group Pnma?

09 October 2012 1,121 0 View

Strange result of a negative film temperature enhancement in 3 omega method measurement

We recently used the 3 omega method to detect the thermal conductivity of a film with about 100nm thickness on a STO substrate with thickness about 500um. In the detection, we strangely found the...

08 September 2012 9,094 6 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

I have get this error when i calculated the geometrical optimization for prco3, it takes 12 hours until gives this message in the outputfile?

Fatal error in MPI_Allreduce: Other MPI error, error stack: MPI_Allreduce(1628)......: MPI_Allreduce(sbuf=000002459254A180, rbuf=000002459F86A140, count=4851, MPI_DOUBLE_COMPLEX, MPI_SUM,...

09 August 2024 7,615 1 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

How effective is the Citi Bloc standard basket in enhancing the accuracy and comparability of international construction cost assessments?

Citi BLOC Standard Basket Definitions: A standardized unit representing a fixed basket of construction materials, labor, and equipment costs priced in various cities. Purpose: To create a common...

04 August 2024 8,997 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Can we eliminate the stress singularity at the tip of the crack by manipulating the elastic constants?

The aim of the research here is to prevent the propagation of the crack in the fabricated elastic medium with useful applications.

25 July 2024 9,976 3 View

Wrong out put for gmx x2top?

Dear users, I would like to simulate a zeolite structure in gromacs. I got the .cif file from IZA expanded in one direction in Materials Studio and exported a .pdb file. However, when I want to...

24 July 2024 367 4 View