Hello Goitsemodimo! Which injection system do you use? Did you try to increase the temperature? Do you get a solvent peak or no signals at all?
Best regards!
First of all You should check pressure of carrier gas, maybe system is not sealed, second think inject solvent and check signal for it. Then check Your system of injection, maybe there is a problem; what was the concentration of analytes? mybe there were lower than LOD? what kind of detector did You use? I hope You will find a resolution very fast:) regards
If No peak exist and no solvent peak appears also. Make sure your detector is on and your injector and liner are ok and if you work with split mode try to reduce the ratio or work with split less mode.
There can be a lot of reasons, some already explained above.
Give details of what you are analyzing and what method you are following with conditions, then it would be easy to sort out the problem.
- Badges
- Science method
- Similar topics
- Chemistry
- General Biochemistry
- Biochemical Techniques
- Analytical Chemistry