I need the full protocol for analysis Chlorophyll a and b, and Anthocyanin for hydroponics lettuce and the ideal solvent for analysis such as acetone for cholophyll and methanol for anthocyanin.
PLZ.look at the following link:Article Non-Destructive Assessment of Chlorophyll Carotenoid and Ant...
You may read following manuscript (Article The effects of red, blue and white light-emitting diodes (LE...
This should be able to help you, for chlorophyll/acetone procedure.
https://pdfs.semanticscholar.org/6f24/5f7f81a1b0035c88a877452cbc54840d98d0.pdf
I have experimented with two Factor: Factor A: Two iron sources and Factor B: two seasons with three blocks. When I run the SAS, the interaction not significant, but the combination of the...
18 May 2020 2,576 6 View
I need Guidelines to write a systematic review in agriculture topic.
24 March 2020 8,050 8 View
I analyzed the plant tissue minerals such as N,P,K by atomic absorption (AAS). I take 0.25g of dry sample and digested. Then filtered and complete the solution to 100ml. The final reading for N,...
23 February 2020 3,164 8 View
What the differences between small scale aquaponics production and low tech aquaponic production in concept, mechanism, components and production.
09 October 2019 1,082 2 View
I want to diluted water sample. The sample volume(10 ml), the reading give me out of range( the range 30 mg/l). amount of Nitrate I have more than 30 mg/L. How i can dilute the water sample to get...
04 May 2019 9,246 12 View
04 May 2019 3,065 1 View
04 May 2019 4,390 13 View
I need to reduce the pH from 7 to 6 by using acetic acid in hydroponics system?
03 April 2019 8,401 7 View
I looking for simple methods or equation for calculation evaporation rate from open tank in aquaculture /aquaponics???
02 March 2019 1,134 1 View
What is the advantages for sump tank in aquaponics
31 December 2018 3,632 1 View
I am making polymer composite by solvent mixing method. When I am trying to add filler solution in polymer solution it quickly get solidified. How to make them then uinform? It doesn't give time...
03 March 2021 7,540 4 View
I am try to make the Paal Knorr reaction between 2.5 hexnedione and 6-amino hexanoic acid, my problem is type of solvent to use, because 6-hexaminohexanoic acid is soluble in water but I am not...
02 March 2021 4,443 2 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
I want to polymerize TEOS on a surface. I know that NH4OH is a preferred catalyst and an alcoholic solvent should be used .But I can not find certain amounts of each material to use. Does any one...
02 March 2021 1,404 6 View
I need a procedure to extract the ciprofloxacin hydrochloride from aqueous solution by using dichloromethane in detail,. I thank you very much.
01 March 2021 4,306 1 View
I am currently doing my third year design project. I have been assigned to design a glycerol recovery column in vinyl acetate monomer production. The process unit before the recovery column is an...
01 March 2021 9,525 4 View
28 February 2021 8,466 2 View
The reaction of APTES with salicylaldehyde in ethanol leads to the formation of imine compound yellow solid which is mention in literature, but I am not getting yellow solid I don't know why? when...
28 February 2021 2,955 2 View
there are solvents and alcohol in the waste water of a factory that produces disinfectants. Increasing this waste water requires very serious operations. Can I treat this waste water with...
27 February 2021 2,609 3 View
I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?
25 February 2021 9,761 1 View