I am looking for a simulator to IOT device authentication based on blockchain without using physical device
currently your best bet is to use raspberry Pi, install Ethereum on it and simulate an IoT + Ethereum network.
https://www.bevywise.com/iot-simulator/
U can check the above link for the simulator u r looking for.
Are you shure that the last IoT simulator permits simulate Blockchain in the network?
In Abaqus I know that there are two methods for incrementation (Automatic and fixed incrementation). I want to control the incrementation by myself. I want to input the values of load increment...
03 February 2021 6,943 3 View
I am doing some staining experiments in mice embryos and I noticed that I lose the zona of pellocida during the procedures. I can not define at exactly which step I lose it but mostly either...
15 October 2020 2,906 2 View
I knew an exciting ritual in Greece, including the sacrifice of children, especially maimed them. Is there sources or studies on this topic .. Thank you for your help
14 October 2020 2,082 4 View
If I have a set of input data and a set of output data as shown in attached file, Can a Neural Network predict an output if the input data out of the given input data? Example: if the new...
11 June 2019 2,899 9 View
i wrote a shallow water equation code on MATLAB but it is solving sequentially and takes a lot of time so i was wondering how can i transform my code to a parallel one so that it can utilize...
29 May 2019 2,759 6 View
Either Mathematica code or other programming tool
11 March 2019 2,765 3 View
I am dealing with silicon nitride powder that has a D50 around 1micron and specific surface area around 10 m2/g. Due to particle-particle & particle-wall collisions in transport lines, I am...
12 September 2018 1,036 4 View
I have a c18 column with a high pressure (2400 psi at flow rate 1 ml/min, acetonitrile:water 50:50). 1_ we use solvents for HPLC and were filtered by nylon paper. 2_ we tried 100% ACN and pressure...
09 May 2018 598 16 View
I tried c18 and platinum columns also ion pair and B_CD were used, no separation was observed. Mobile phase , 90:10 v/v aqueous to organic solvent with and without buffer were not effective.
19 December 2017 494 2 View
30 January 2017 3,155 3 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...
24 February 2021 1,598 2 View
Increasingly, more articles are being retracted because of duplicate or otherwise dubious Western blots. Consequently, journals are asking for original Western blots and authentication of...
23 February 2021 8,609 3 View
Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...
23 February 2021 1,761 1 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View
For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...
21 February 2021 7,624 3 View
Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...
21 February 2021 2,333 4 View