I need a free 2D & 3D DIC (Digital Image Correlation)
We should dilute the STF with some solvent like ethanol. When ethanol evaporated after coating, the STF has been so dry to rheology testing . Do you think there is a need to use alcohol to get...
09 October 2018 449 0 View
Moreover, as shown in Figure 7 (d), the morphologies of silica nanoparticles could be clearly seen, and the dispersion was remarkably uniform. The article can be viewed from the link...
10 November 2017 4,489 1 View
I think one of the best ways to obtain friction of the fabric is using Yarn pull-out. For example, in the figure below, We did a test (yarn pull-out), and what do you think about obtain...
01 January 1970 9,963 2 View
the complete formula is log (F/A) = log k + n log (N/A). where A is the area of contact in yarn pull-out test. this formula used for obtain friction coefficient.
01 January 1970 6,205 2 View
I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...
03 March 2021 4,116 4 View
I have selected brain tumor images ...but now found that already lots of research done n this topic.
03 March 2021 5,774 3 View
i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).
03 March 2021 7,100 1 View
Need to image mesoporous silica nanoparticles using the TEM. Also, need high resolution TEM images to see the mesoporous structure. Kindly suggest what kind of grids to use. Thanks, Shatadru
02 March 2021 1,787 2 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
Dear Colleagues, After running Western blot on PVDF membrane and detection using ECL, I would like to stain my PVDF with colloidal gold to be able to allign the ECL image with total proteins on...
02 March 2021 7,829 3 View
Working on chandrayaan-2 DFSAR data, there are three datasets available: 1) Slant range image data product: The slant range complex image file. Each pixel is represented by two 4-byte floating...
02 March 2021 8,481 3 View
I would like to research on MR images (0.5T and 3T). Can you please suggest some websites that I can download dataset including both 0.5T and 3T MR images? Thank you.
02 March 2021 7,735 3 View
Hello, I have classified 10 S3 OLCI images from the same area (althouth not the same size and/or quadrant) and I would like to do a final image using the mode of the pixel of these 10 images. I...
01 March 2021 9,874 3 View
Hi everyone, I am using Fiji to determine the percentage of the image covered by leaves, branches, or trunk, but i've encountered some difficulty when the sun hits parts of my image like the one...
27 February 2021 1,194 3 View
