It is known that the solver only takes the value of gauge pressure only when the flow is subsonic.
So what should be the value for gauge pressure??
Should it be ambient pressure?
I observed in some manuals and websites for performing transient simulation in Fluent that UDF (sinusoidal profile of pressure) has been used at the pressure outlet of the domain. Is it necessary...
10 November 2019 5,480 4 View
I am simulating a transient supersonic flow in CD nozzle. After the flow has evolved, the solution is reaching steady-state. What might be the reason the reason for it? It seems that with each...
04 May 2019 7,478 17 View
I am doing transient simulation of compressible flow over forward facing step. The pressure ratio maintained is 5.5 bar. Whether it is k-epsilon or k-omega it is diverging only when the low mach...
10 November 2018 2,968 10 View
I want to have a time variation of pressure at the outlet, maybe sinusoidal to do unsteady simulation of compressible flow in nozzle. Could you please share the unsteady_compressible.zip file...
01 January 1970 8,236 2 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...
21 July 2024 1,680 2 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
Hello everyone. I am working on my LV concentration porject, I use 500Kda hollowfiber to do it. The HCP and BSA removal rate is nearly 80%, but last time, I failed to run it. The HCP hasn't been...
11 July 2024 5,380 0 View
I want to reduce simulation time in CST for frequency domain solver by upgrading my computer. I already have discrete GPU but it doesn't seem to make any difference at all compared to integreted...
10 July 2024 2,789 4 View
What will be the pressure in Iron Iron-Carbide diagram? It is at atmospheric pressure?
05 July 2024 1,891 0 View
I am trying to simulate velocity field inside a domain of just ambient air (pressure is 1 atm & velocity is 10 m/s). There is a tank inside it which has a leakage. The leakage hole is leaking...
01 July 2024 2,249 0 View
Hi All, My name is Sumaiya, a PhD student at the University of Queensland. I am looking for some suggestions on how to hold mice and perform Randall-Selitto Test by using Paw Pressure Randall...
30 June 2024 6,004 0 View
I would like to dedicate my entire life in doing only one activity alone and nothing else. How do I achieve it in this world full of unavoidable distractions and societal pressures?
24 June 2024 298 1 View