helo dear Gaurang joshi,
I want know what kind of aluminium do you weld in this work, because actually I'm working on Al 6082 TIG welding and I have some question a bout it, thank you.
We are working on AL6061 T651
6061 Al alloy
what do you want to know
when it's necessary to increase rotation of tool and welding speed, and when it's necessary to decrease. according to hardness of the material.
05 March 2016 2,152 2 View
according to several studies on friction stir welding the presence of intermetallics in welded zone is harmful and deteriorate the properties of the joint, but in the case of low alloy steel...
04 March 2016 4,789 7 View
There are three operating parameters - the laser power, the diameter of the focus spot and the scanning speed. It is necessary to obtain a seam of a given depth without pores. What parameter...
27 July 2024 7,168 2 View
How can the rubber fibres produced by the electrospinning device be removed from the fibre collector (aluminium foil) without affecting the orientation of the rubber fibres for use in reinforcing...
26 July 2024 8,281 0 View
Would an average spot welder suffice for welding tabs for pouch cell electrodes instead of an ultrasonic one? Why would an ultrasonic welder be better than a regular spot welder?
10 July 2024 8,763 0 View
I synthesise intermetallic compounds through nickel and aluminium powders. But the pure powder after synthesis is difficult to obtain. Especially the presence of aluminium oxide very seriously...
01 July 2024 4,030 3 View
we need surface area, corrosion current, equivalent weight and density of the metal involved for corrosion rate calculation in mm/year (lets say). For dissimilar metal welds, how can we measure...
30 June 2024 5,943 2 View
My idea was to prepare discal shaped iron-oxide using Al3+ metal-ion mediated solution to regulate the morphology of of my nanoparticles, but most literature uses aluminium acetate and not...
22 June 2024 6,136 2 View
I am using apparent heat method for simulation
14 June 2024 4,670 1 View
I conducted a tensile test to analyze the strength of a welded joint and to implement an FEM model. Due to the high hardness of the base material, slippage between the grip and the base material...
10 June 2024 5,736 6 View
I want to realize a auto-analyze process for weld fatigue by fe-safe software. However, I found that the current.macro in Tools can not record the commands of the GUI operation about defining the...
04 June 2024 5,089 1 View
Hello, I have modeled a steel conical roof in Abaqus. Now I want to model the location of a groove weld in Abaqus in a spiral pattern from the bottom to the top of the roof. How should I model...
04 June 2024 9,833 1 View