What is the thermal expansion coeficient for BaTiO3 at high temperatures 900 - 1200 °C ?

More Přemysl Šťastný's questions See All

Stress level monitoring without baseline of hearth rate?

Hey guys, I'm looking for advise. We want to measure stress level during task in virtual reality. We are using simple heart rate monitoring, unfortunately not to accurate but sufficient. But we...

19 September 2019 8,160 1 View

How to measure immediate stress response?

Excluding pupilometry, is there any method, how to measure immedate stress response? First I was thinking about hearth rate than about skin conductivity. In both cases there is to long delay...

05 September 2018 9,695 3 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,989 3 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

How Can I Apply Hashin Damage Properties to Solid Elements in Abaqus Without Using VUMAT?

Sure, here is the translation: I have a 3D orthogonal woven composite structure where warp, weft, and binder yarns are oriented in three directions. After modeling these yarns and the matrix in...

28 July 2024 8,169 0 View

In terms of chaos, what is the necessary and sufficient condition for authoritarianism, permanent or temporary, to come to exist and persist?

Since 2016 Brexit, the world needed to change the thinking behind traditional democracy as the democratic landscape changed, yet traditional democratic thinkers and actors have been acting as if...

28 July 2024 6,515 1 View

Hongyao Jia

Sorry， I don't know whether there is a source we can check for the expansion coefficients for BaTiO3 within 900-1200℃. Usually, I choose to measure the coefficient of a BaTiO3 ceramic sample on the testing facility.

Andreas Leineweber

https://scholar.google.de/scholar?hl=de&as_sdt=0%2C5&q=batio3+thermal+expansion&btnG=