What is the sample size to study quality of laboratory like lab errors, critical result reporting and TAT?

More Girum Tesfaye Kiya's questions See All

How to do data arrangement or what to do?

I hope all you are doing well. I want to learn how to do data arrangement for evaluation of relative contributions of different variables on a response variable of my interest for meta-analysis...

16 August 2023 157 3 View

Unit Conversion needed or not needed??

Dear friends, I am doing meta-analysis and the results of N2O emissions from different incubation experiments are reported in different units, shall I do unit conversion or does not need to made...

23 November 2022 8,785 2 View

Can I use an independent sample t test with non-normally distributed data if I have large sample size?

Up on checking my data (large sample size of 11,008) on histogram, it showed almost normally distributed, slightly skewed to the one side. But the Kolmogorov-Smirnov Test for Normality indicated...

01 September 2021 5,378 14 View

Why Single factor model in using CFA become low as compared with higher order , bi factor, and correlated factor models?

I have research entitled "Teacher well-being". In my first study, the study participants were very small and removed almost half of the items. However, after discussing with my Professor and...

05 April 2021 7,206 4 View

Which post hoc test should I use in my research ?

I want to analyze my data on age, university type, income, educational qualification, teaching experience with three categories. A little bit I have faced some challenges of normality...

03 April 2021 2,289 5 View

Is there any specific natural ventilation standard for schools in terms of ACH for the current pandemic?

Schools are reopening and most standard setting agencies are recommending adequate natural ventilation should be maintained when schools are re-opened. Is there a specific quantitative natural...

21 October 2020 5,741 4 View

Which method is best for testing model Fitness while using Hierarchical logistic regression with large data sets?

Which method is best for testing model Fitness while using Hierarchical logistic regression using large data sets?

03 October 2020 8,247 4 View

Why does the Cronbach Alpha reliability and the CFA Composite reliability (CR) are different?

I am questioning my self and check the Cronbach Alpha reliability and the CFA Composite reliability (CR) results. The results are not the same. maybe is there any technical problem between of the...

16 November 2019 1,001 3 View

How can we statistically compare difference between two trends?

I have seen many researches that compare trend difference between two or more groups. However none have statistically compared the trend difference, then i searched why? and I found no clear...

26 February 2018 9,947 6 View

Which distribution type should I use when calculating the average particle size from TEM image? and how to calculate the error ?

average particle size calculation from TEM

04 August 2024 2,921 1 View

How to calculate effect size of AMCE (Average Marginal Component Effect) in Randomized Conjoint Experiment?

I am following Hainmueller, Hopkins, and Yamamoto's (2014) paper for my randomized conjoint experimental data analysis. The link to the paper is provided below. I received a comment from the...

02 August 2024 4,406 0 View

Difficulty with permittivitt and Magnetic Permeability Calculations?

Difficulty with permittivitt and Magnetic Permeability Calculations Hello everyone, I have all the parameters related to the calculations of the permittivitty and magnetic permeability...

30 July 2024 5,206 1 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

How to conduct a sensitivity power analysis for Kendall's Tau?

Is there a straightforward way to conduct a sensitivity power analysis for a Kendall's Tau correlation? I was considering using the sensitivity setting and "Correlation: point biserial model" test...

28 July 2024 6,133 8 View

How to estimate sample size for GWAS of continuous and discrete traits? What are the pre-requisites?

Genome-wide association study (GWAS) Continuous traits: eg. Height Discrete traits: eg. Eye color

28 July 2024 286 0 View

All math can be explained by iterator of code?

all math can be traversed by code? all math can be translate to code?

26 July 2024 9,530 0 View

What is the best method for removing paraffin from plant samples prepared for microtome?

...

24 July 2024 3,087 3 View

What is human-computer interaction (HCI)?

22 July 2024 10,056 2 View

How many samples size should I select to compare both groups?

I want to study the differences between two groups: the treatment group and the comparison group. The total population consists of 60000 women in the treatment group, distributed across different...

21 July 2024 669 3 View

C K Gomathy

Hi,

Quality indicators in the clinical laboratory provide a useful tool for continuous improvement of laboratory services. ... A total of 84250 samples were processed, and the quality indicators monitored were classified into the following 3 categories: preanalytical, analytical, and post-analytical.

Productive in the Lab activities:

Plan your day.

Track time spent on tasks.

Put spare time to good use.

Know when you are at your best.

Maintain a Clutter-Free Environment.

Keep an accounting system for all supplies and materials.

Keep your data organized.

Divide and Conquer. For more info..kindly check:https://pdfs.semanticscholar.org/76c7/1b40af4649bf31c11222f439fca02ee429a5.pdf

Jianjun Qin

There should be no correct answer to this. Only the size would be inverse proportional to the error.