Dear Husham,

First of all, you have to forecast the wind speed or the sunlight radiation in candidate locations (you can also use available data presented in different papers, instead).

Then, you should devise a mathematical model for your wind turbine (WT) or PV (you can find a typical model in so many papers). Keep in mind that the economic model is considered in planning (long-term) studies.

Finally, solve the optimization model in order to get the optimal location of WTs or PVs.

I recommend you study the worthwhile papers of Dr. Geev Mokrani in this matter.

Regards,

Morteza Shabanzadeh

http://mortezash.blogfa.com/

Chapter Optimal Siting and Sizing of Wind Turbines Based on Genetic ...

Article Strategic placement of distribution network operator owned w...

Article Assessing Wind Turbines Placement in a Distribution Market E...

Article Optimal wind turbines placement within a distribution market...

 Dear Dr. Morteza Shabanzadeh

Thank you very much for your answer and for your help

Dear Husham

Besically embedded generator means microgrid type i.e there is a very samal amount of energy generate form these type generator.....so if we use these type of generator in grid or in transmission line to bust the voltage then it will very flexible for the system.

Dear Malaya KUMAR Rout

Thank you for your  answer it was very useful .

Regards

Dear Husham,

Have look at the following papers as well as their worthwhile references.

Good luck,

Morteza

Article Optimal Pseudo-Dynamic Planning of MV Radial Distribution Ne...

Conference Paper Optimum Sitting, Sizing and Timing of Utility and Non-Utilit...

Dear Husham

it is  my pleasure to  make this conversation with you.