when I want to amplify DNA with thermal cycler this message will appear when I touch the cover at once. so that I have to restart the device to continue and some times it happens will amplifying because the cover be too hot.
what is the reason for that and what are the solution for this problem?
Dose it harm the device if we continue to use?
or what can I do ?
It looks as though your lid temp controller has malfunctioned. Usually, when a temp controller fails on, it indicates that the active control device (likely a MOSFET or SCR) has shorted. This is the most likely failure mode for these devices. If the device is still under warranty, you should contact the company for a repair. There is some possibility of a software problem that may reset if you power down the device, let it cool to room temperature, and power it back up. Good luck!
Yes, I think Ron is right. It says "Fatal Error" and "asks you to contact technical support".
I would not continue to use it before I contact the company. It might become worse if you continue to use it.
- Badges
- Science topic
- Similar topics
- Biological Science
- Bioscience
- Biotechnology