I need matlab code of Horn Radiation pattern DualPol Antenna
To simulate horn antenna radiation pattern using MATLAB
Dear, check this link:
https://www.scribd.com/doc/70971893/simulation-of-antenna-radiation-pattern-horn
Thanks my Dear
My research interests are GIS
Interested
NS2 (Network Simulator)
06 July 2018 2,215 10 View
4-way traffic light design by Labview simulation
02 March 2017 1,448 5 View
How can design jammer system by Simulink Matlab?
09 October 2016 9,232 2 View
Hello all, In SPSS I am going to code 2 open-ended questions. I have already read all the answers and I made a list of the most important categories to which I can code the answers. This question...
02 March 2021 1,757 4 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
I have designed reflectarray element to generate OAM beams at 5.8GHz and feeding it though Horn Antenna on HFSS. After full wave simulation, i am not getting desired results i.e Radiation pattern...
01 March 2021 9,701 5 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...
28 February 2021 6,560 14 View
Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...
28 February 2021 7,016 1 View
I have designed a 24 GHz rectangular antenna on HFSS 3D model and got desired results while desing the same antenna with same dimensions I am getting resonance frequency at 27 GHz I am...
28 February 2021 4,426 2 View
I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...
28 February 2021 3,459 3 View
28 February 2021 5,433 3 View
I am working on modeling and simulation of biomecanical material behaviour, I have succeded on simulating skin using anisotropic hyperelastic material, on APDL and in our lab's finite element...
28 February 2021 552 3 View